Search results
Results from the WOW.Com Content Network
Gable (ridged, dual-pitched, peaked, saddle, pack-saddle, saddleback, [5] span roof [6]): A simple roof design shaped like an inverted V. Cross gabled: The result of joining two or more gabled roof sections together, forming a T or L shape for the simplest forms, or any number of more complex shapes.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
Greek: the ridge height is 1 ⁄ 9 to 1 ⁄ 7 the span (an angle of 12.5° to 16°); Roman: the ridge height is 2 ⁄ 9 to 1 ⁄ 3 the span (an angle of 24° to 34°); Common: the rafter length is 3 ⁄ 4 the span (about 48°); Gothic: the rafters equal the span (60°); and; Elizabethan: the rafters are longer than the span (more than 60°). [7]
Glulam brace with plates used for connections Glulam frame of a roof structure. Glued laminated timber, commonly referred to as glulam, is a type of structural engineered wood product constituted by layers of dimensional lumber bonded together with durable, moisture-resistant structural adhesives so that all of the grain runs parallel to the longitudinal axis.
Timber roof truss example. The top members of a truss are known generically as the top chord, bottom members as the bottom chord, and the interior members as webs.In historic carpentry the top chords are often called rafters, and the bottom chord is often referred to as a tie beam.
Waffle slabs are preferred for spans greater than 40 feet (12 m), because, for a given mass of concrete, they are much stronger than flat slabs, flat slabs with drop panels, two-way slabs, one-way slabs, and one-way joist slabs. [2] Section of a waffle slab including beam, ribs, and column head
The LH- and DLH-Series have been designed for the purpose of extending the use of joists to spans and loads in excess of those covered by Open Web Steel Joists, K-Series. LH-Series Joists have been standardized in depths from 18 inches (460 mm) through 48 inches (1,200 mm), for spans through 96 feet (29,000 mm).
Diagram of double tee beam. A double tee or double-T beam is a load-bearing structure that resembles two T-beams connected to each other side by side. The strong bond of the flange (horizontal section) and the two webs (vertical members, also known as stems) creates a structure that is capable of withstanding high loads while having a long span.