Search results
Results from the WOW.Com Content Network
Today, the shell is also used in the manufacture of decorative items, including mobiles, chandeliers, Christmas lanterns (the parol), and various other products. [2] [1] [3] A piece of capiz shell. Panels from the early centuries of capiz-shell window-making show tight mortise and tenon lap joints on the frames, done using only chisels and ...
Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.
An elbow is installed between two lengths of pipe (or tubing) to allow a change of direction, usually a 90° or 45° angle; 22.5° elbows are also available. The ends may be machined for butt welding, threaded (usually female), or socketed. When the ends differ in size, it is known as a reducing (or reducer) elbow.
About half of the world's PVC production capacity is in China, despite the closure of many Chinese PVC plants due to issues complying with environmental regulations and poor capacities of scale. The largest single producer of PVC as of 2018 is Shin-Etsu Chemical of Japan , with a global share of around 30%.
Plastic Pipe lengths manufactured in Australia by extruding HDPE material.. Plastic pipe is a tubular section, or hollow cylinder, made of plastic.It is usually, but not necessarily, of circular cross-section, used mainly to convey substances which can flow—liquids and gases (fluids), slurries, powders and masses of small solids.
Tanks smaller than 7,500 liters (2,000 gallons) are easily manufactured out of cheaper materials, such as HDPE or PVC. Tanks larger than four meters are generally limited by shipping constraints, and the economics suggest a concrete or steel tank fabricated at the tank's location .
The PNCC was established in 1966 by virtue of an executive order during the administration of the Former President Ferdinand Marcos as the Construction and Development Corporation of the Philippines (CDCP), with the corporation being led by Rodolfo Cuenca, a crony. It was granted a 50-year franchise to commission and perform construction works ...
ASEP exists in the advancement of structural engineering in the Philippines as well as upholding ethical values in the promotion of national and international professional collaboration with governments, industry and the academe. [4] The organization specifically lobbies on legislation of the Philippines [5] in the national and local levels.