Search results
Results from the WOW.Com Content Network
The most significant difference between the two is that 6N2P has its two filament elements connected in parallel, unlike the series filament connection of the 12AX7, and it is thus only possible to operate it from a 6.3 volt, 340 mA filament supply (whereas a 12AX7 may be operated from either 6.3 or 12.6 volts, at 300 mA or 150 mA, respectively.)
Axi-symmetric stall, more commonly known as compressor surge; or pressure surge, is a complete breakdown in compression resulting in a reversal of flow and the violent expulsion of previously compressed air out through the engine intake, due to the compressor's inability to continue working against the already-compressed air behind it.
A compressor map is a chart which shows the performance of a turbomachinery compressor. This type of compressor is used in gas turbine engines, for supercharging reciprocating engines and for industrial processes, where it is known as a dynamic compressor. A map is created from compressor rig test results or predicted by a special computer program.
"Frost-Free" refrigerator/freezer units usually use a heating element to defrost their evaporators, a pan to collect and evaporate water from the frost that melts from the cold plate and/or evaporator coil, a timer which turns off the compressor and turns on the defrost element usually from once to 4 times a day for periods usually ranging from ...
Alternatively, a liquid-to-liquid or similar heat exchanger may be used instead. The high-temperature system transfers heat to a conventional condenser that carries the entire heat output of the system and may be passive, fan, or water-cooled. This is an auto-cascade process with two different refrigerants.
In air conditioning, an inverter compressor is a compressor that is operated with an inverter. In the hermetic type, it can either be a scroll or reciprocating compressor . This type of compressor uses a drive to control the compressor motor speed to modulate cooling capacity.
12AX7 (also known as ECC83 [1]) is a miniature dual-triode vacuum tube with high voltage gain. Developed around 1946 by RCA engineers [ 2 ] in Camden, New Jersey , under developmental number A-4522, it was released for public sale under the 12AX7 identifier on September 15, 1947.
On civil turbofans, the first stage of the LP compressor is often a single-stage fan. If the HP compressor pressure ratio exceeds about 4.5:1, then the unit will probably have variable geometry (i.e. variable stators) on the first few stages, to make the surge line on the compressor map more shallow, to accommodate the shallow working line.