enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Torx - Wikipedia

    en.wikipedia.org/wiki/Torx

    An External Torx version exists, also known as Inverted Torx, where the screw head has the shape of a Torx screwdriver bit, and a Torx socket is used to drive it. The external "E" Torx nominal sizing does not correlate to the "T" size, (e.g. an E40 socket is too large to fit a T40 Torx bit, while an E8 Torx socket will fit a T40 Torx bit [6]).

  3. List of screw drives - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_drives

    An external Torx screw has a projecting head in the shape of a Torx screwdriver bit (instead of a standard recessed cavity); a Torx socket is used to drive it. The external "E" Torx nominal sizing does not correspond to the "T" size (for example, an E40 socket is too large to fit a T40, while an E8 Torx socket will fit a T40 Torx bit [68 ...

  4. Robertson screw - Wikipedia

    en.wikipedia.org/wiki/Robertson_screw

    Screwdriver bits in different sizes for Robertson screws. When Henry Ford tried the Robertson screws, he found that they saved considerable time in Model T production. When Robertson refused to license the design, Ford realized that the supply of screws would not be guaranteed, and chose to limit their use to his Canadian division. [4] [5] [6]

  5. List of drill and tap sizes - Wikipedia

    en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

    For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use. The 85% and 90% rules works best in the range of 1 ⁄ 4 –1 in (6.4–25.4 mm), the sizes most important on many shop floors. Some sizes outside that range have different ...

  6. Screwdriver - Wikipedia

    en.wikipedia.org/wiki/Screwdriver

    This size number is usually stamped onto the shank (shaft) or handle for identification. Each bit size fits a range of screw sizes, more or less well. Each Phillips screwdriver size also has a related shank diameter. The driver has a 57° point and tapered, unsharp (rounded) flutes.

  7. Computer case screws - Wikipedia

    en.wikipedia.org/wiki/Computer_case_screws

    The #6-32 UNC screw has a thread pitch of 1/32 in (0.031250 inches (0.7938 mm)).. The #6-32 UNC is a UTS screw specifying a major thread diameter of #6 which is defined as 0.1380 inches (3.51 mm); and 32 tpi (threads per inch) which equates to a thread pitch of 0.031250 inches (0.7938 mm).

  8. Drill bit sizes - Wikipedia

    en.wikipedia.org/wiki/Drill_bit_sizes

    Number drill bit gauge sizes range from size 80 (the smallest) to size 1 (the largest) followed by letter gauge size A (the smallest) to size Z (the largest). Although the ASME B94.11M twist drill standard, for example, lists sizes as small as size 97, sizes smaller than 80 are rarely encountered in practice.

  9. Torque screwdriver - Wikipedia

    en.wikipedia.org/wiki/Torque_screwdriver

    Manual torque screwdriver with torx bit. A torque screwdriver is a screwdriver with components that ensure tightening to a specified torque, ensuring tightening which is sufficient, but not excessive. An insufficiently tightened screw connection may loosen in operation, and excessive tightening can damage parts; for example, if the nuts holding ...