enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. How Much Does it Cost to Replace a Roof? - AOL

   www.aol.com/much-does-cost-replace-roof...

   The higher the square footage, the more your roof replacement will cost. For a 1,500 square foot roof, homeowners can expect to spend between $6,525 and $16,500 in total. Roof Pitch

3. Flashing (weatherproofing) - Wikipedia

   en.wikipedia.org/wiki/Flashing_(weatherproofing)

   In earlier days, birch bark was occasionally used as a flashing material. [7] Most flashing materials today are metal, plastic, rubber, or impregnated paper. [8]Metal flashing materials include lead, aluminium, copper, [1] stainless steel, zinc alloy, other architectural metals or a metal with a coating such as galvanized steel, lead-coated copper, anodized aluminium, terne-coated copper ...

4. Fascia (architecture) - Wikipedia

   en.wikipedia.org/wiki/Fascia_(architecture)

   Fascia (/ ˈ f eɪ ʃ ə /) is an architectural term for a vertical frieze or band under a roof edge, or which forms the outer surface of a cornice, visible to an observer. [ 1 ] Typically consisting of a wooden board, unplasticized PVC (uPVC), or non-corrosive sheet metal, many of the non-domestic fascias made of stone form an ornately carved ...

5. Framing (construction) - Wikipedia

   en.wikipedia.org/wiki/Framing_(construction)

   Exterior wall studs are the vertical members to which the wall sheathing and cladding are attached. [14] They are supported on a bottom plate or foundation sill and in turn support the top plate. Studs usually consist of 1 + 1 ⁄ 2 -by- 3 + 1 ⁄ 2 -inch (38 mm × 89 mm) or 1 + 1 ⁄ 2 -by- 5 + 1 ⁄ 2 -inch (38 mm × 140 mm) lumber and are ...

6. Fiber cement siding - Wikipedia

   en.wikipedia.org/wiki/Fiber_cement_siding

   Sheet sizes vary slightly from manufacturer to manufacturer but generally they range between 2400 – 3000 mm in length and 900 –1200mm in width (600 & 450 mm increments). This manufactured size minimizes on-site wastage as residential floor, wall and roof structures lay structural members at 450 or 600mm centres.

7. Terne - Wikipedia

   en.wikipedia.org/wiki/Terne

   Historical terne metal must be painted. Terne metal can last 90 years or more if the paint is maintained. Terne-coated stainless steel (TCS II or Roofinox), or copper is commonly used to replace terne metal roofs as either material will outlast terne metal. Terne-coated stainless steel roofing can last 100 years or more unpainted; copper ...