enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Plumbing fixture - Wikipedia

   en.wikipedia.org/wiki/Plumbing_fixture

   Each of these plumbing fixtures has one or more water outlets and a drain. In some cases, the drain has a device that can be manipulated to block the drain to fill the basin of the fixture. Each fixture also has a flood rim, or level at which water will begin to overflow. Most fixtures also have an overflow, which is a conduit for water to ...

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Piping or tubing is usually inserted into fittings to make connections. Connectors are assigned a gender, abbreviated M or F. An example of this is a "3 ⁄ 4-inch female adapter NPT", which would have a corresponding male connection of the same size and thread standard (in this case also NPT).

4. Did You Know You Can Get a Refund on Your Water Bill if Your ...

   www.aol.com/finance/did-know-refund-water-bill...

   If you have a leaky faucet, you could receive a refund from your water company. All you need to do is fix or replace the faucet and submit proof to your water company.

5. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   A fibre washer (which expands when wet, aiding the seal) is used between the connector and the tap tail. Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size.

6. Fixture unit - Wikipedia

   en.wikipedia.org/wiki/Fixture_unit

   A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...

7. Wall plug - Wikipedia

   en.wikipedia.org/wiki/Wall_plug

   In 1957, Oswald Thorsman from Sweden received a patent for a plastic wall plug; around the same time, German inventor Artur Fischer created the plastic Fischer wall plug. [4] [5] The Fischer wall plug, due to its innovative shape, was the first to be suitable for all wall types, and has since been the most produced and sold wall plug worldwide ...