Search results
Results from the WOW.Com Content Network
Today "dual LNB" (and "dual feed") describes antennas for reception from two satellite positions, using either two separate LNBs or a single Monoblock LNB with two feedhorns. In the UK, the term "twin-output LNB", or simply "twin LNB", is usually used for an LNB with a single feedhorn but two independent outputs. [3]
Two monoblock LNB can be connected to one receiving dish using Multi-satellite techniques. However, the expected results of such connections may vary or be sub-optimal. The results may yield low-level signals from some or all of the satellites or it may work well in certain geographically favorable locations.
An example of a system utilizing both a BUC and an LNB is a VSAT system, used for bidirectional Internet access via satellite. The block upconverter is a block shaped device assembled with the LNB in association with an OMT, orthogonal mode transducer to the feed-horn that faces the reflector parabolic dish. This is opposed to other types of ...
A twin-output Duo LNB fitted to a 60 cm dish with only one output connected. (Note that this LNB is mounted using the 19.2°E feedhorn, not in accordance with SES' installation guidelines) A Duo LNB is a double low-noise block downconverter (LNB) developed by SES for the simultaneous reception of satellite television signals from both the Astra ...
In addition, control signals are also transmitted from the receiver to the LNB through the cable. The receiver uses different power supply voltages (13 / 18 V) to select vertical / horizontal antenna polarization, and an on/off pilot tone (22 kHz) to instruct the LNB to select one of the two frequency bands. In larger installations each band ...
For small numbers of receivers a multi-output LNB is used and all the feeds are taken straight from the LNB but there is a limit to the number of outputs that can reasonably be placed on a LNB. So for larger installations a quattro LNB is used in conjunction with a multiswitch. The quattro LNB provides the signals for all four of the modes at ...
Feed horn with concentric rings (left) and LNB (right) on a Hughes DirecWay home satellite dish. An LNBF (LNB with integrated feed horn) that has been cut into two.Visible is the scalar horn antenna (the funnel with concentric rings), which couples the microwave beam into a short waveguide (the tube connecting the feed horn to the LNB electronics part of the LNBF).
In an optical fibre system at the LNB the four sub-bands are "stacked" in frequency, one above the other, at 0.95 GHz-3.0 GHz (the whole frequency range received in vertical polarisation) and 3.4 GHz-5.45 GHz (horizontal polarisation) and transmitted together as a modulated optical signal down the fibre cable using a 1310 nm semiconductor laser.