Search results
Results from the WOW.Com Content Network
A low-noise block downconverter (LNB) is the receiving device mounted on satellite dishes used for satellite TV reception, which collects the radio waves from the dish and converts them to a signal which is sent through a cable to the receiver inside the building.
Monoblock (or monobloc) low-noise block downconverters are a special type of LNBs representing a single device that contains several (typically 2–4) LNB units and a Digital Satellite Equipment Control (DiSEqC) switch. The latter allows the recipient to receive signals from several neighboring satellites each communicating different channels ...
An example of a system utilizing both a BUC and an LNB is a VSAT system, used for bidirectional Internet access via satellite. The block upconverter is a block shaped device assembled with the LNB in association with an OMT, orthogonal mode transducer to the feed-horn that faces the reflector parabolic dish. This is opposed to other types of ...
A twin-output Duo LNB fitted to a 60 cm dish with only one output connected. (Note that this LNB is mounted using the 19.2°E feedhorn, not in accordance with SES' installation guidelines) A Duo LNB is a double low-noise block downconverter (LNB) developed by SES for the simultaneous reception of satellite television signals from both the Astra ...
Special LNBs have been developed for use in single-cable distribution systems. All four sub-bands of the Ku band (low frequency/horizontal polarity, high frequency/horizontal polarity, low frequency/vertical polarity, high frequency/vertical polarity) are received by a conventional front end, amplified and downconverted to the L-band, to be fed to a number of SatCR (Satellite Channel Router ...
In addition, control signals are also transmitted from the receiver to the LNB through the cable. The receiver uses different power supply voltages (13 / 18 V) to select vertical / horizontal antenna polarization, and an on/off pilot tone (22 kHz) to instruct the LNB to select one of the two frequency bands. In larger installations each band ...
In an optical fibre system at the LNB the four sub-bands are "stacked" in frequency, one above the other, at 0.95 GHz-3.0 GHz (the whole frequency range received in vertical polarisation) and 3.4 GHz-5.45 GHz (horizontal polarisation) and transmitted together as a modulated optical signal down the fibre cable using a 1310 nm semiconductor laser.
Feed horn with concentric rings (left) and LNB (right) on a Hughes DirecWay home satellite dish. An LNBF (LNB with integrated feed horn) that has been cut into two.Visible is the scalar horn antenna (the funnel with concentric rings), which couples the microwave beam into a short waveguide (the tube connecting the feed horn to the LNB electronics part of the LNBF).