Search results
Results from the WOW.Com Content Network
Dragon beam is a horizontal, diagonal beam in the corner (s) of some traditional timber-framed buildings. The term is commonly used in both hip roof framing and jettying. Older publications may use the synonyms dragging beam, dragging piece, dragging tie, dragon piece or dragon tie. Inconsistencies in modern usage are discussed below.
This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof. Trusses usually occur at regular intervals, linked by longitudinal timbers such as purlins. The space between each truss is known ...
Coyau or sprocket. Labeled A. A rafter is one of a series of sloped structural members such as steel beams that extend from the ridge or hip to the wall plate, downslope perimeter or eave, and that are designed to support the roof shingles, roof deck, roof covering and its associated loads. [2] A pair of rafters is called a couple.
Ctrs. means centers, a typical line to which carpenters layout framing. Domestic roof construction is the framing and roof covering which is found on most detached houses in cold and temperate climates. [1] Such roofs are built with mostly timber, take a number of different shapes, and are covered with a variety of materials.
History. The reciprocal frame, also known as a Mandala roof, [1] has been used since the twelfth century in Chinese and Japanese architecture although little or no trace of these ancient methods remain. More recently they were used by architects Kazuhiro Ishii (the Spinning House) and Yasufumi Kijima, and engineer Yoishi Kan (Kijima Stonemason ...
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
The purlins are the large beams perpendicular to the rafters; from this shot, it appears that there are three purlins on either side of the roof. The sheathing boards are sometimes called the roof deck and are painted white. A purlin (or historically purline, purloyne, purling, perling) is a longitudinal, horizontal, structural member in a roof.
A truss is an assembly of members such as beams, connected by nodes, that creates a rigid structure. [1] In engineering, a truss is a structure that "consists of two-force members only, where the members are organized so that the assemblage as a whole behaves as a single object". [2] A "two-force member" is a structural component where force is ...