enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hall effect sensor - Wikipedia

   en.wikipedia.org/wiki/Hall_effect_sensor

   Hall effect current sensor with internal integrated circuit amplifier. 8 mm opening. Zero current output voltage is midway between the supply voltages that maintain a 4 to 8-volt differential. The non-zero current response is proportional to the voltage supplied and is linear to 60 amperes for this particular (25 A) device.

3. SENT (protocol) - Wikipedia

   en.wikipedia.org/wiki/SENT_(protocol)

   The SAE J2716 SENT (Single Edge Nibble Transmission) protocol [1] is a point-to-point scheme for transmitting signal values from a sensor to a vehicle controller. It is intended to allow for transmission of high resolution data with a low system cost.

4. Current sensing - Wikipedia

   en.wikipedia.org/wiki/Current_sensing

   Fiber optic current sensor, using an interferometer to measure the phase change in the light produced by a magnetic field. Rogowski coil, electrical device for measuring alternating current (AC) or high speed current pulses. Giant Magnetoresistance(GMR): Magnetic field sensor suitable for AC & DC Current with higher accuracy than Hall Effect ...

5. Birkeland current - Wikipedia

   en.wikipedia.org/wiki/Birkeland_current

   Schematic of the Birkeland or Field-Aligned Currents and the ionospheric current systems they connect to, Pedersen and Hall currents. [1]A Birkeland current (also known as field-aligned current, FAC) is a set of electrical currents that flow along geomagnetic field lines connecting the Earth's magnetosphere to the Earth's high latitude ionosphere.

6. Transition-edge sensor - Wikipedia

   en.wikipedia.org/wiki/Transition-edge_sensor

   Optical image of four tungsten transition-edge sensors for near-infrared single-photon detection. Image credit: NIST. A transition-edge sensor (TES) is a type of cryogenic energy sensor or cryogenic particle detector that exploits the strongly temperature-dependent resistance of the superconducting phase transition.

7. SAE J1772 - Wikipedia

   en.wikipedia.org/wiki/SAE_J1772

   Control Pilot (Current limit): The charging station can use the wave signal to describe the maximum current that is available via the charging station with the help of pulse-width modulation: a 16% PWM is a 10 A maximum, a 25% PWM is a 16 A maximum, a 50% PWM is a 32 A maximum and a 90% PWM flags a fast charge option.

8. Electronic test equipment - Wikipedia

   en.wikipedia.org/wiki/Electronic_test_equipment

   The following are used for stimulus of the circuit under test: Power supplies; Signal generator; Digital pattern generator; Pulse generator; Voltcraft M-3850 portable multimeter. The following analyze the response of the circuit under test: Oscilloscope (Displays voltage as it changes over time) Frequency counter (Measures frequency)

9. DIN 72552 - Wikipedia

   en.wikipedia.org/wiki/DIN_72552

   limit 33b field 54e 33f 2. slow rpm: 33g 3. slow rpm 33h 4. slow rpm 33L rotation left 30L 33R rotation right 30R Indicators 49 flasher unit in 15, 15+, 15/54, +, +15, X 49a flasher unit out, indicator switch in 54L, S, S4, L 49b out 2. flasher circuit 49c out 3. flasher circuit C 1st flasher indicator light K, K1, P C2 2nd flasher indicator light