enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wood (golf) - Wikipedia

   en.wikipedia.org/wiki/Wood_(golf)

   The shaft length in woods varies from about 40–48 inches (101.6–121.9 cm), with the current standard length for the driver being 45 in (114.3 cm), formerly 43.5 in (110.5 cm). Graphite shafts are usually preferred for woods due to their light weight, which enables users to generate higher clubhead speeds and thus greater distance.

3. Long drive - Wikipedia

   en.wikipedia.org/wiki/Long_drive

   Long drive clubs, which are always drivers, differ in several ways from consumer clubs. Until the recent club length limitation rules, the shafts were much longer than a normal 45 in (114.3 cm) shaft, sometimes exceeding 55 in (139.7 cm). In 2005, a 50 in (127.0 cm) limitation was introduced (measured vertically).

4. Shaft (golf) - Wikipedia

   en.wikipedia.org/wiki/Shaft_(golf)

   The shaft is roughly .58 inch/14.7 millimeters in diameter near the grip and between 35 and 48 inches/89–115 cm in length. Shafts weigh between 45 and 150 grams depending on the material and length. Graphite shafts are woven from carbon fiber and are generally lighter in weight than steel shafts. Graphite shafts became popular among amateurs ...

5. Golf club - Wikipedia

   en.wikipedia.org/wiki/Golf_club

   The shaft is roughly 0.5 inches (13 mm) in diameter near the grip and from 34 to 48 inches (86 to 122 cm) in length. Shafts weigh from 45 to 150 grams (1.6 to 5.3 oz), depending on the material and length. [2] Shafts are quantified in a number of different ways. The most common is the shaft flex.

6. Drive shaft - Wikipedia

   en.wikipedia.org/wiki/Drive_shaft

   A drive shaft, driveshaft, driving shaft, tailshaft (Australian English), propeller shaft (prop shaft), or Cardan shaft (after Girolamo Cardano) is a component for transmitting mechanical power, torque, and rotation, usually used to connect other components of a drivetrain that cannot be connected directly because of distance or the need to ...

7. Dana 44 - Wikipedia

   en.wikipedia.org/wiki/Dana_44

   Naturally the cast housing is also unique to the IRS model. Standard 8.5" Dana 44 ring and pinion gear can be used in the IRS model through the use of an installation kit which includes special shouldered bolts to mount the standard ring gear to the IRS carrier and a special pinion bearing set to fit the standard pinion shaft to the IRS housing.