Search results
Results from the WOW.Com Content Network
Spill occurs when sound is detected by a microphone not intended to pick it up (for example, the vocals being detected by the microphone for the guitar). [3] Spill is often undesirable in popular music recording, [4] as the combined signals during the mix process can cause phase cancellation and may cause difficulty in processing individual tracks. [2]
The microphone arm of headsets may carry an external microphone or be of the voice tube type. External microphone designs have the microphone housed in the front end of the microphone arm. Voicetube designs are also called internal microphone design, and have the microphone housed near the earpiece, with a tube carrying sound to the microphone.
A conventional microphone placed on, or a few inches above, a hard boundary surface will pick up the desired direct sound as well as delayed sound reflecting off the boundary surface. The direct and delayed reflected sounds will combine at the microphone to create comb filtering , with constructive and destructive interference causing peaks and ...
[10] When using multiple microphones, respecting a 3-to-1 rule and placing microphones at least three times further from each other than they are from the source they are being used to pick up avoids cancellation and phase issues such as comb filtering when the microphone signals are mixed together. [11]
Headsets are made with either a single-earpiece (mono) or a double-earpiece (mono to both ears or stereo). The microphone arm of headsets is either an external microphone type where the microphone is held in front of the user's mouth, or a voicetube type where the microphone is housed in the earpiece and speech reaches it by means of a hollow tube.
Contact microphones have been used to pick up the sound of a snail's heartbeat and the footsteps of ants. A portable version of this microphone has recently been developed. A throat microphone is a variant of the contact microphone that picks up speech directly from a person's throat, which it is strapped to. This lets the device be used in ...
A ribbon microphone, also known as a ribbon velocity microphone, is a type of microphone that uses a thin aluminum, duraluminum or nanofilm of electrically conductive ribbon placed between the poles of a magnet to produce a voltage by electromagnetic induction. Ribbon microphones are typically bidirectional, meaning that they pick up sounds ...
The internal electronic circuitry of an active noise-canceling mic attempts to subtract noise signal from the primary microphone. The circuit may employ passive or active noise canceling techniques to filter out the noise, producing an output signal that has a lower noise floor and a higher signal-to-noise ratio .