enow.com Web Search

  1. Ads

    related to: utp patch cable vs ethernet switch for tv wireless router

Search results

  1. Results from the WOW.Com Content Network
  2. Patch cable - Wikipedia

    en.wikipedia.org/wiki/Patch_cable

    A patch cable, patch cord or patch lead is an electrical or fiber-optic cable used to connect ("patch in") one electronic or optical device to another for signal routing. Devices of different types (e.g., a switch connected to a computer, or a switch to a router ) are connected with patch cords.

  3. Ethernet crossover cable - Wikipedia

    en.wikipedia.org/wiki/Ethernet_crossover_cable

    An Ethernet crossover cable is a crossover cable for Ethernet used to connect computing devices together directly. It is most often used to connect two devices of the same type, e.g. two computers (via their network interface controllers ) or two switches to each other.

  4. Structured cabling - Wikipedia

    en.wikipedia.org/wiki/Structured_cabling

    Regardless of copper cable type (Cat 5e/6/6A), the maximum distance is 90 m for the permanent link installation, plus an allowance for a combined 10 m of patch cords at the ends. Cat 5e and Cat 6 can both effectively run power over Ethernet (PoE) applications up to 90 m. However, due to greater power dissipation in Cat 5e cable, performance and ...

  5. Networking cable - Wikipedia

    en.wikipedia.org/wiki/Networking_cable

    Networking cable is a piece of networking hardware used to connect one network device to other network devices or to connect two or more computers to share devices such as printers or scanners. Different types of network cables, such as coaxial cable , optical fiber cable , and twisted pair cables, are used depending on the network's topology ...

  6. Modular connector - Wikipedia

    en.wikipedia.org/wiki/Modular_connector

    A cable wired as T568A at one end and wired as T568B at the other end (Tx and Rx pairs reversed) is an Ethernet crossover cable. Before the widespread acceptance of auto MDI-X capabilities, a crossover cable was needed to interconnect similar network equipment (such as Ethernet hubs to Ethernet hubs).

  7. Ethernet over twisted pair - Wikipedia

    en.wikipedia.org/wiki/Ethernet_over_twisted_pair

    Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. Cables for Ethernet may be wired to either the T568A or T568B termination standards at both ends of the cable. Since these standards differ only ...

  1. Ads

    related to: utp patch cable vs ethernet switch for tv wireless router