enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Schematic of a machine tap. Below is a comprehensive drill and tap size chart for all drills and taps, imperial and metric, up to 36.5 millimetres (1.44 in) in diameter.. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

3. Ceramic tile cutter - Wikipedia

   en.wikipedia.org/wiki/Ceramic_tile_cutter

   First Tile Cutter Invented by Boada Brothers. The ceramic tile cutter works by first scratching a straight line across the surface of the tile with a hardened metal wheel and then applying pressure directly below the line and on each side of the line on top. Snapping pressure varies widely, some mass-produced models exerting over 750 kg.

4. Power tool - Wikipedia

   en.wikipedia.org/wiki/Power_tool

   The introduction of the electric motor (and electric distribution networks) in the 1880s made possible the self-powered stationary and portable tools we know today. [19] The global market for power tools is $33 billion (in 2016) and estimated to reach $46 billion in 2025.

5. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   The bit shown in the picture is a modern design for use in portable power tools, made in the UK in about 1995. It has a single spur, a single radial cutting edge and a single flute. Similar auger bits are made with diameters from 6 mm (3/16 in) to 30 mm (1 3/16 in).

6. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   For Morse taper-shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to 3¼ inches, and a single 1/4 inch increment to 3½ inches. One aspect of this method of sizing is that the size increment between drill bits ...

7. Drill - Wikipedia

   en.wikipedia.org/wiki/Drill

   A standard hammer drill accepts 6 mm (1/4 inch) and 13 mm (1/2 inch) drill bits. The operator experiences considerable vibration, and the cams are generally made from hardened steel to avoid them wearing out quickly. In practice, drills are restricted to standard masonry bits up to 13 mm (1/2 inch) in diameter.