Search results
Results from the WOW.Com Content Network
The "correct" procedure is to decide upon one's move, then remove one stone from the bowl and place it on the board. This produces the minimal amount of distraction for one's opponent. When removing a stone from its bowl to make a move, place a flat hand on the edge of the bowl, with the fingers gently entering the bowl.
The RCSC specification has been adopted, in its entirety, by the American Institute of Steel Construction and appears as section 16 of that organization's Steel Construction Manual. DTIs within the RCSC specification section 8.2.4 are described thus: "ASTM F959 direct tension indicators are recognized in this Specification as a bolt-tension ...
These vary in significant ways, such as the method used to count the final score, and in very small ways, such as whether the two kinds of "bent four in the corner" positions result in removal of the dead stones automatically at the end of the game or whether the position must be played out, and whether the players must start the game with a ...
Assorted washers: flat, split, star and insulating. A washer is a thin plate (typically disk-shaped, but sometimes square) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such as a bolt or nut.
Threaded sleeves: consist of a tube with an internal thread which is anchored back into the concrete. For all the type of the cast-in-place anchors, the load-transfer mechanisms is the mechanical interlock, [3] i.e. the embedded part of the anchors in concrete transfers and the applied load (axial or shear) via bearing pressure at the contact zone.
Fasteners commonly used with piping are a stud bolt [26] with nuts (usually fully threaded, with two heavy, hexagonal nuts); a machine bolt and nut; or a powder-actuated tool (PAT) fastener (usually a nail or threaded stud, driven into concrete or masonry).
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Aqueous parts cleaning industrial washer Parts cleaning is a step in various industrial processes , either as preparation for surface finishing or to safeguard delicate components. One such process, electroplating , is particularly sensitive to part cleanliness, as even thin layers of oil can hinder coating adhesion .