enow.com Web Search

  1. Ads

    related to: bypass water softener for outside hose connector

Search results

  1. Results from the WOW.Com Content Network
  2. Backflow prevention device - Wikipedia

    en.wikipedia.org/wiki/Backflow_prevention_device

    Backflow prevention device. The simplest, most reliable way to provide backflow prevention is to provide an air gap.An air gap is simply an open vertical space between any device that connects to a plumbing system (like a valve or faucet) and any place where contaminated water can collect or pool.

  3. Reduced pressure zone device - Wikipedia

    en.wikipedia.org/wiki/Reduced_pressure_zone_device

    Some normal water use conditions may cause short episodes of discharge (this is why check one has a minimum passing value of relief +3. It is designed to handle the pressure fluctuations). In the case of the upstream check valve passing, the differential pressure (higher supply pressure compared with the lower chamber pressure) causes any flow ...

  4. Hose coupling - Wikipedia

    en.wikipedia.org/wiki/Hose_coupling

    A selection of Storz hose couplings. A hose coupling is a connector on the end of a hose to connect (or couple) it with another hose or with a tap or a hose appliance, such as an irrigation sprinkler. It is usually made of steel, brass, stainless steel, aluminium or plastic.

  5. Pressure regulator - Wikipedia

    en.wikipedia.org/wiki/Pressure_regulator

    Pressure regulator for domestic water supply. Outlet pressure is set with the blue handwheel and shown on the vertical scale. A water pressure regulating valve limits inflow by dynamically changing the valve opening so that when less pressure is on the outside, the valve opens up fully, and too much pressure on the outside causes the valve to shut.

  6. Nipple (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Nipple_(plumbing)

    Nipple. In plumbing and piping, a nipple is a fitting, consisting of a short piece of pipe, usually provided with a male pipe thread at each end, for connecting two other fittings.

  7. Tap (valve) - Wikipedia

    en.wikipedia.org/wiki/Tap_(valve)

    Taps are normally connected to the water supply by means of a "swivel tap connector", which is attached to the end of the water pipe using a soldered or compression fitting, and has a large nut to screw onto the threaded "tail" of the tap, which hangs down underneath the bath, basin or sink.

  1. Ads

    related to: bypass water softener for outside hose connector