Search results
Results from the WOW.Com Content Network
Return loss is a measure of how well devices or lines are matched. A match is good if the return loss is high. A high return loss is desirable and results in a lower insertion loss. From a certain perspective 'Return Loss' is a misnomer. The usual function of a transmission line is to convey power from a source to a load with minimal loss.
This is the actual mode of operation for most high-speed differential interconnects and is the quadrant that receives the most attention. It includes input differential return loss (SDD11), input differential insertion loss (SDD21), output differential return loss (SDD22) and output differential insertion loss (SDD12).
If you accept that the reflection coefficient is equivalent to the S11 scattering parameter of the load, and that Z0 is the impedance the load sees looking out of its port, i.e. the source impedance, then the formula as written contradicts the definition of S11 (see Scattering_parameters). S11 is defined as b1/a1; a1 is defined as (1/2) K1 (V1 ...
For example, a certain antenna used well away from its resonant frequency may have an SWR of 6:1. For a frequency of 3.5 MHz, with that antenna fed through 75 meters of RG-8A coax, the loss due to standing waves would be 2.2 dB. However the same 6:1 mismatch through 75 meters of RG-8A coax would incur 10.8 dB of loss at 146 MHz.
The Smith chart (sometimes also called Smith diagram, Mizuhashi chart (水橋チャート), Mizuhashi–Smith chart (水橋スミスチャート), [1] [2] [3] Volpert–Smith chart (Диаграмма Вольперта—Смита) [4] [5] or Mizuhashi–Volpert–Smith chart), is a graphical calculator or nomogram designed for electrical and electronics engineers specializing in radio ...
In telecommunications, balance return loss is one of two things: A measure of the degree of balance between two impedances connected to two conjugate sides of a hybrid set, coil, network, or junction. A measure of the effectiveness with which a balancing network simulates the impedance of a two-wire circuit at a hybrid coil.
In real systems, relatively little loss is due to mismatch loss and is often on the order of 1dB [dubious – discuss]. According to Walter Maxwell [2] mismatch does not result in any loss ("wasted" signal), except through the transmission line. This is because the signal reflected from the load is transmitted back to the source, where it is re ...
The formulas given in the previous section allow one to calculate the point estimates of α and β — that is, the coefficients of the regression line for the given set of data. However, those formulas do not tell us how precise the estimates are, i.e., how much the estimators α ^ {\displaystyle {\widehat {\alpha }}} and β ^ {\displaystyle ...