enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Micrometer (device) - Wikipedia

   en.wikipedia.org/wiki/Micrometer_(device)

   A micrometer, sometimes known as a micrometer screw gauge (MSG), is a device incorporating a calibrated screw widely used for accurate measurement of components [1] in mechanical engineering and machining as well as most mechanical trades, along with other metrological instruments such as dial, vernier, and digital calipers.

3. Bore gauge - Wikipedia

   en.wikipedia.org/wiki/Bore_gauge

   An inside micrometer or vernier bore gauge measures a bore directly. The gauge has three symmetrical anvils that protrude from the gauge body that are connected to the dial or micrometer mechanism. As the knob is rotated it moves the anvils in or out with respect to the measurements.

4. Gauge (instrument) - Wikipedia

   en.wikipedia.org/wiki/Gauge_(instrument)

   Hole gauge [3] used to gage internal dimensions of bores that are either too small in diameter for an inside micrometer, and have greater economy than a bore gage or other precision internal gage. Caliper: a device used to measure the distance between two opposing sides of an object. Center gauges and fishtail gauges

5. Calipers - Wikipedia

   en.wikipedia.org/wiki/Calipers

   Two inside calipers. Inside calipers are used to measure the internal size of an object. The upper caliper in the image (on the right) requires manual adjustment prior to fitting. Fine setting of this caliper type is performed by tapping the caliper legs lightly on a handy surface until they will almost pass over the object.

6. Mitutoyo - Wikipedia

   en.wikipedia.org/wiki/Mitutoyo

   Mitutoyo America Corporation was formed in 1963 and is headquartered in Aurora, Illinois (just outside Chicago).Mitutoyo America offers the full product line of precision measuring tools, instruments and equipment with a distribution network, training and education classes, software development, and service support to provide a comprehensive metrology organization.

7. Gauge block - Wikipedia

   en.wikipedia.org/wiki/Gauge_block

   A small number of gauge blocks can be used to create accurate lengths within a wide range. By using three blocks at a time taken from a set of 30 blocks, one may create any of the 1000 lengths from 3.000 to 3.999 mm in 0.001 mm steps (or .3000 to .3999 inches in 0.0001 inch steps).