Search results
Results from the WOW.Com Content Network
In this equation, L and V refer to the lateral and vertical forces acting upon the rail and wheel, δ is the angle made when the wheel flange is in contact with the rail face, and μ is the coefficient of friction between the wheel and the rail. [1] Typically, the axle load for a railway vehicle should be such that the lateral forces of the ...
Generally, the depth of the girder is no less than 1 ⁄ 15 the span, and for a given load bearing capacity, a depth of around 1 ⁄ 12 the span minimizes the weight of the girder. Stresses on the flanges near the centre of the span are greater than near the end of the span, so the top and bottom flange plates are frequently reinforced in the ...
Since the girts are normally fastened to, or near, the exterior flange of a column, stability braces may be installed at a girt to resist rotation of the unsupported, inner flange of the primary member. The girt system must be competent and adequately stiff to provide the required stabilizing resistance in addition to its role as a wall panel ...
A one-way, low-speed (OWLS) diamond in Champaign, Illinois.This is an example of flange-bearing frogs in use on North American freight rail lines. A flange-bearing frog, often abbreviated FBF, is a type of frog in which the flange of the wheel on a railway vehicle supports the weight of the vehicle.
A railway wheel's tread and flange and its relationship to the load-bearing rail. The running surface of most train wheels is conical, which serves as the primary means of keeping the train aligned with the track while in motion. The wheels are fixed on an axle, and when rounding a curve the mass of the train pushes the wheelset towards the ...
The axle load of a wheeled vehicle is the total weight bearing on the roadway for all wheels connected to a given axle.Axle load is an important design consideration in the engineering of roadways and railways, as both are designed to tolerate a maximum weight-per-axle (axle load); exceeding the maximum rated axle load will cause damage to the roadway or railway tracks.
The main function of an OWSJ is to provide direct support for roof or floor deck and to transfer the load imposed on the deck to the structural frame i.e. beam and column. In order to accurately design an OWSJ, engineers consider the joist span between bearing points, joist spacing, slope, live loads , dead loads , collateral loads, seismic ...
The dimension of a wide-flange I-beam. In the United States, steel I-beams are commonly specified using the depth and weight of the beam. For example, a "W10x22" beam is approximately 10 in (254 mm) in depth with a nominal height of the I-beam from the outer face of one flange to the outer face of the other flange, and weighs 22 lb/ft (33 kg/m).