Search results
Results from the WOW.Com Content Network
Moghadasi et alios [10] evaluated Corey, Chierici and LET correlations for oil/water relative permeability using a sophisticated method that takes into account the number of uncertain model parameters. They found that LET, with the largest number (three) of uncertain parameters, was clearly the best one for both oil and water relative permeability.
Craig [1] proposed three rules of thumb for interpretation of wettability from relative permeability curves. These rules are based on the value of interstitial water saturation, the water saturation at the crossover point of relative permeability curves (i.e., where relative permeabilities are equal to each other), and the normalized water permeability at residual oil saturation (i.e ...
Thermodynamically the flow of substances from one compartment to another can occur in the direction of a concentration or electrochemical gradient or against it. If the exchange of substances occurs in the direction of the gradient, that is, in the direction of decreasing potential, there is no requirement for an input of energy from outside the system; if, however, the transport is against ...
The concept of permeability is of importance in determining the flow characteristics of hydrocarbons in oil and gas reservoirs, [4] and of groundwater in aquifers. [5]For a rock to be considered as an exploitable hydrocarbon reservoir without stimulation, its permeability must be greater than approximately 100 md (depending on the nature of the hydrocarbon – gas reservoirs with lower ...
TEM-function in analyzing relative permeability data is analogous with Leverett J-function in analyzing capillary pressure data. Furthermore, TEM-function in two-phase flow systems is an extension of RQI (rock quality index) for single-phase systems.
= where a = water, oil, gas. and and are absolute and relative permeability, respectively. These 3 (vector) equations models flow of water, oil and natural gas in subsurface oil and gas reservoirs in porous rocks.
Correlating relative permeability. The simulation model computes the saturation change of three phases (oil, water and gas) and the pressure of each phase in each cell at each time step. As a result of declining pressure as in a reservoir depletion study, gas will be liberated from the oil.
In petroleum engineering, the Leverett J-function is a dimensionless function of water saturation describing the capillary pressure, [1] = / where is the water saturation measured as a fraction, is the capillary pressure (in pascal), is the permeability (measured in m²), is the porosity (0-1), is the surface tension (in N/m) and is the contact angle.