enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Pump as turbine - Wikipedia

   en.wikipedia.org/wiki/Pump_As_Turbine

   Conversely, a double flow radially split pump/PAT design involves a single radial open rotor fed by two symmetric inlets and enable processing a higher flow rate with respect to a standard radial unit. [9] A second type of pump/PAT design is the axial one, in which the fluid interacts with a propeller following a trajectory parallel to the pump ...

3. Comparison of pumps - Wikipedia

   en.wikipedia.org/wiki/Comparison_of_pumps

   Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...

4. Radial piston pump - Wikipedia

   en.wikipedia.org/wiki/Radial_piston_pump

   no axial internal forces at the drive shaft bearing; high reliability; A disadvantage is the bigger radial dimensions in comparison to the axial piston pump, but it could be compensated with the shorter construction in axial direction.

5. Rotodynamic pump - Wikipedia

   en.wikipedia.org/wiki/Rotodynamic_pump

   In these types of pumps the volute casing is split axially and the split line at which the pump casing separates is at the shaft's centerline. They are typically mounted horizontally due to ease in installation and maintenance. Radial split: The pump case is split radially, the volute casing split is perpendicular to shaft centre line.

6. Radial turbine - Wikipedia

   en.wikipedia.org/wiki/Radial_turbine

   The difference between axial and radial turbines consists in the way the fluid flows through the components (compressor and turbine). Whereas for an axial turbine the rotor is 'impacted' by the fluid flow, for a radial turbine, the flow is smoothly oriented perpendicular to the rotation axis, and it drives the turbine in the same way water ...

7. Spur gear - Wikipedia

   en.wikipedia.org/wiki/Spur_gear

   Spur gear. Spur gears or straight-cut gears are the simplest type of gear. They consist of a cylinder or disk with teeth projecting radially. Viewing the gear at 90 degrees from the shaft length (side on) the tooth faces are straight and aligned parallel to the axis of rotation. Looking down the length of the shaft, a tooth's cross section is ...

8. Jim Gaffigan on adjusting to the painful new reality: "How ...

   www.aol.com/jim-gaffigan-adjusting-painful...

   How are you holding up? Are you over it? I'm over it. I'm fine. At least, at times I think that. It's obviously not what I wanted but that's life. I'm not going to lie. It been an adjustment, but ...

9. Centrifugal pump - Wikipedia

   en.wikipedia.org/wiki/Centrifugal_pump

   Warman centrifugal pump in a coal preparation plant application A pair of centrifugal pumps for circulating hot water within a hydronic heating system. Centrifugal pumps are used to transport fluids by the conversion of rotational kinetic energy to the hydrodynamic energy of the fluid flow. The rotational energy typically comes from an engine ...