enow.com Web Search

  1. Ads

    related to: 5/8 galvanized wire rope cable connectors fittings

Search results

  1. Results from the WOW.Com Content Network
  2. Cable railing - Wikipedia

    en.wikipedia.org/wiki/Cable_railing

    Typical diameters are 1/8", 3/16" for residential and 3/16" and 1/4" for commercial applications. [5] There are many different types cable and strand (also referred to as wire rope). Cable and strand is available in galvanized carbon steel, type 304 stainless steel, or the highly corrosion resistant, type 316 stainless steel (best for coastal ...

  3. Cable gland - Wikipedia

    en.wikipedia.org/wiki/Cable_gland

    Split cable gland KVT for routing pre-terminated cables. A cable gland (more often known in the U.S. as a cord grip, cable strain relief, cable connector or cable fitting) is a device designed to attach and secure the end of an electrical cable to the equipment. [1]

  4. Wire rope - Wikipedia

    en.wikipedia.org/wiki/Wire_rope

    The end of a wire rope tends to fray readily, and cannot be easily connected to plant and equipment. There are different ways of securing the ends of wire ropes to prevent fraying. The common and useful type of end fitting for a wire rope is to turn the end back to form a loop. The loose end is then fixed back on the wire rope.

  5. FASTON terminal - Wikipedia

    en.wikipedia.org/wiki/FASTON_terminal

    The terminal system consists of tabs (male) and receptacles (female). There are free-hanging wire and circuit board mounted versions of both tabs and receptacles. All widths come mostly in one of two tab thicknesses: 0.032 and 0.020 in (0.8 and 0.5 mm). A hand tool exists for inserting the terminals: the AMP Universal Handle. [citation needed]

  6. Twist-on wire connector - Wikipedia

    en.wikipedia.org/wiki/Twist-on_wire_connector

    A connector more closely resembling the present-day twist-on type was patented in Canada by Marr in 1931, and in the US in 1933. "Wire Connector", Canadian Patent CA 311638 Issued 26 May 1931. "Wire Connecter" U.S. patent 1,896,322, Filed November 24, 1930, Patented February 7, 1933

  7. IEC 60309 - Wikipedia

    en.wikipedia.org/wiki/IEC_60309

    The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.

  1. Ads

    related to: 5/8 galvanized wire rope cable connectors fittings