enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Continuity test - Wikipedia

   en.wikipedia.org/wiki/Continuity_test

   In electronics, a continuity test is the checking of an electric circuit to see if current flows (that it is in fact a complete circuit). A continuity test is performed by placing a small voltage (wired in series with an LED or noise-producing component such as a piezoelectric speaker ) across the chosen path.

3. Continuity tester - Wikipedia

   en.wikipedia.org/wiki/Continuity_tester

   Entry-level cable testers are essentially continuity testers. A continuity tester is an item of electrical test equipment used to determine if an electrical path can be established between two points; [1] that is if an electrical circuit can be made. The circuit under test is completely de-energized prior to connecting the apparatus. [1]

4. Multimeter - Wikipedia

   en.wikipedia.org/wiki/Multimeter

   Analog multimeter Digital multimeter. A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [2] [3] A typical multimeter can measure voltage, resistance, and current, [4] in which case can be used as a voltmeter, ohmmeter, and ammeter.

5. Electronic test equipment - Wikipedia

   en.wikipedia.org/wiki/Electronic_test_equipment

   The following items are used for basic measurement of voltages, currents, and components in the circuit under test. Voltmeter (Measures voltage) Ohmmeter (Measures resistance) Ammeter, e.g. Galvanometer or Milliammeter (Measures current) Multimeter e.g., VOM (Volt-Ohm-Milliammeter) or DMM (Digital Multimeter) (Measures all of the above)

6. Cable tester - Wikipedia

   en.wikipedia.org/wiki/Cable_tester

   There are two common ways to test a connection: A continuity test. Current is passed down the connection. If there is current the connection is assumed to be good. This type of test can be done with a series combination of a battery (to provide the current) and a light bulb (that lights when there is a current). A resistance test. A known ...

7. Electrical safety testing - Wikipedia

   en.wikipedia.org/wiki/Electrical_safety_testing

   Continuity test: a test to check the wiring is correct Earth continuity test: this test is to make sure the earthing system is properly connected Live testing. Earth fault loop impedance testing: this test is to check that if a fault did occur, that the system meets requirements to cause a disconnection of the supply within the time limit ...