enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Sliding window protocol - Wikipedia

    en.wikipedia.org/wiki/Sliding_window_protocol

    A sliding window protocol is a feature of packet-based data transmission protocols. Sliding window protocols are used where reliable in-order delivery of packets is required, such as in the data link layer ( OSI layer 2 ) as well as in the Transmission Control Protocol (i.e., TCP windowing ).

  3. Automatic repeat request - Wikipedia

    en.wikipedia.org/wiki/Automatic_repeat_request

    Variations of ARQ protocols include Stop-and-wait ARQ, Go-Back-N ARQ, and Selective Repeat ARQ. All three protocols usually use some form of sliding window protocol to help the sender determine which (if any) packets need to be retransmitted. These protocols reside in the data link or transport layers (layers 2 and 4) of the OSI model.

  4. Retransmission (data networks) - Wikipedia

    en.wikipedia.org/wiki/Retransmission_(data_networks)

    Retransmission, essentially identical with automatic repeat request (ARQ), is the resending of packets which have been either damaged or lost. Retransmission is one of the basic mechanisms used by protocols operating over a packet switched computer network to provide reliable communication (such as that provided by a reliable byte stream, for example TCP).

  5. Transmission Control Protocol - Wikipedia

    en.wikipedia.org/wiki/Transmission_Control_Protocol

    TCP uses a sliding window flow control protocol. In each TCP segment, the receiver specifies in the receive window field the amount of additionally received data (in bytes) that it is willing to buffer for the connection. The sending host can send only up to that amount of data before it must wait for an acknowledgment and receive window update ...

  6. Flow control (data) - Wikipedia

    en.wikipedia.org/wiki/Flow_control_(data)

    A method of flow control in which a receiver gives a transmitter permission to transmit data until a window is full. When the window is full, the transmitter must stop transmitting until the receiver advertises a larger window. [5] Sliding-window flow control is best utilized when the buffer size is limited and pre-established.

  7. Stop-and-wait ARQ - Wikipedia

    en.wikipedia.org/wiki/Stop-and-wait_ARQ

    The above behavior is a basic example of Stop-and-Wait. However, real-life implementations vary to address certain issues of design. Typically the transmitter adds a redundancy check number to the end of each frame. The receiver uses the redundancy check number to check for possible damage. If the receiver sees that the frame is good, it sends ...

  8. The Hardest Working Royal of 2024 Is... - AOL

    www.aol.com/lifestyle/hardest-working-royal-2024...

    Yui Mok - WPA Pool/Getty Images. Princess Anne secured the top spot, yet again, with 217 royal engagements and a 2.4% increase from 2023, according to the report.November was her busiest month ...

  9. Selective Repeat ARQ - Wikipedia

    en.wikipedia.org/wiki/Selective_Repeat_ARQ

    When used as the protocol for the delivery of messages, the sending process continues to send a number of frames specified by a window size even after a frame loss. Unlike Go-Back-N ARQ , the receiving process will continue to accept and acknowledge frames sent after an initial error; this is the general case of the sliding window protocol with ...