Search results
Results from the WOW.Com Content Network
CAN FD (Controller Area Network Flexible Data-Rate) is a data-communication protocol used for broadcasting sensor data and control information on 2 wire interconnections between different parts of electronic instrumentation and control system. This protocol is used in modern high performance vehicles.
These sensors, after being calibrated at the factory, are able to provide digital data concerning processor temperature information. The PECI bus , allowing access to this data from chipset components, is a proprietary single-wire interface with a variable data transfer speed (from 2 kbit/s to 2 Mbit/s).
CAN FD (Flexible Data-Rate), standardized as ISO 11898-1, was developed by Bosch and released in 2012 to meet the need for increased data transfer in modern high-performance vehicles. It offers variable data rates during the transmission of a single frame, allowing the arbitration phase to occur at a lower data rate for robust communication ...
Speed: 2.4 kbit/s to 1 Gbit/s; Modulation: baseband, no carrier; Infrared window (part of the device body transparent to infrared light beam) Wavelength: 850–900 nm; The frame size depends on the data rate mostly and varies between 64 B and 64 kB. Additionally, bigger blocks of data can be transferred by sending multiple frames consecutively.
ARINC 429, [1] the "Mark 33 Digital Information Transfer System (DITS)," is the ARINC technical standard for the predominant avionics data bus used on most higher-end commercial and transport aircraft. [2] It defines the physical and electrical interfaces of a two-wire data bus and a data protocol to support an aircraft's avionics local area ...
The typical applications are high-speed video, graphics, video camera data transfers, and general purpose computer buses. Early on, the notebook computer and LCD display vendors commonly used the term LVDS instead of FPD-Link when referring to their protocol, and the term LVDS has mistakenly become synonymous with Flat Panel Display Link in the ...
The Simple Sensor Interface (SSI) protocol is a simple communications protocol designed for data transfer between computers or user terminals and smart sensors. The SSI protocol has been developed jointly by Nokia , Vaisala , Suunto , Ionific, Mermit and University of Oulu .
Therefore, transferring data as a bulk would yield a better performance in terms of higher throughput. Sliding window flow control is a point to point protocol assuming that no other entity tries to communicate until the current data transfer is complete. The window maintained by the sender indicates which frames it can send.