enow.com Web Search

  1. Ads

    related to: 15mm female to male coupler size

Search results

  1. Results from the WOW.Com Content Network
  2. Gender of connectors and fasteners - Wikipedia

    en.wikipedia.org/wiki/Gender_of_connectors_and...

    A3F = Audio 3-pin Female connector; A3M = Audio 3-pin Male connector. The terms plug, pin, and prong are also often used for "male" connectors, and receptacle, socket, and slot are used for "female" connectors. In many cases these terms are more common than male and female, especially in documentation intended for the non-specialist. These ...

  3. SMA connector - Wikipedia

    en.wikipedia.org/wiki/SMA_connector

    The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.

  4. Micro ribbon connector - Wikipedia

    en.wikipedia.org/wiki/Micro_ribbon_connector

    [citation needed] The larger size has 0.085 inch (2.16 mm) contact pitch. This size, with 36 pins and bail locks, is also known as a Centronics connector because of its introduction by Centronics for use with the parallel port of printers, and is standardized as IEEE 1284 type B. Other connectors of this size are also called Centronics connectors.

  5. FASTON terminal - Wikipedia

    en.wikipedia.org/wiki/FASTON_terminal

    Six series are covered in one of TE's catalogs (which omits the 0.375 in/9.5 mm, but mentions it elsewhere), named after their blade width in mils. [2] Insulated versions of the terminals are color-coded to indicate what wire gauges they may be used with. The terminal system consists of tabs (male) and receptacles (female).

  6. DC connector - Wikipedia

    en.wikipedia.org/wiki/DC_connector

    The corresponding notch in the female connector body is 1.8 ± 0.1 mm (0.071 ± 0.004 in) wide and ends at a radius of 6.2 ± 0.1 mm (0.244 ± 0.004 in) from the connector centre. With the angles measured clockwise looking at the female connector (counter-clockwise looking at the male), the various key positions indicate:

  7. Electrical connector - Wikipedia

    en.wikipedia.org/wiki/Electrical_connector

    Bullet terminals, male and female (right-center, with blue wires) A blade connector is a type of single wire, plug-and-socket connection device using a flat conductive blade (plug) that is inserted into a receptacle. Wires are typically attached to male or female blade connector terminals by either crimping or soldering. Insulated and ...

  1. Ads

    related to: 15mm female to male coupler size