Search results
Results from the WOW.Com Content Network
Parallel ATA (PATA), originally AT Attachment, also known as Integrated Drive Electronics (IDE), is a standard interface designed for IBM PC-compatible computers.It was first developed by Western Digital and Compaq in 1986 for compatible hard drives and CD or DVD drives.
ATAPI (ATA Packet Interface) is a protocol used with the Parallel ATA (IDE) and Serial ATA standards so that a greater variety of devices can be connected to a computer than with the ATA command set alone.
Moving the HDD controller from the interface card to the disk drive helped to standardize the host/controller interface, reduce the programming complexity in the host device driver, and reduced system cost and complexity. The 40-pin IDE/ATA connection transfers 16 bits of data at a time on the data cable.
Around 1997, with the introduction of ATAPI-4 (and thus Ultra-DMA-Mode, which enabled fast data transfers with less CPU utilization) the first ATA RAID controllers were introduced as PCI expansion cards. Those RAID systems made their way to the consumer market, for users wanting the fault-tolerance of RAID without investing in expensive SCSI ...
The IT8212, or more correctly the IT8212F, is a low-end Parallel ATA controller designed by ITE Tech. Depending on the implemented BIOS and configuration the IT8212F functions in either a RAID or an ATAPI mode, supporting up to four devices using dual channels.
Integrated Drive Electronics (IDE, ATA/ATAPI, PATA) Intelligent Platform Management Interface (IPMI) 2.0 2004/02/14 Micro Channel Architecture (MCA)
A few early SCSI drives were actually ST-506 drives with a SCSI to ST-506 controller on the bottom of the drive. [13] Atari also used Adaptec ACB-4000A SCSI to ST-506 converter inside its own line of SH204/SH205 external ACSI drives. [14] Likewise a few early IDE drives were just drives with an ST-412 interface attached to a controller board or ...
Native Command Queuing was preceded by Parallel ATA's version of Tagged Command Queuing (TCQ). ATA's attempt at integrating TCQ was constrained by the requirement that ATA host bus adapters use ISA bus device protocols to interact with the operating system. The resulting high CPU overhead and negligible performance gain contributed to a lack of ...