Search results
Results from the WOW.Com Content Network
The resistance of copper 16-gauge or heavier speaker connection cable has no detectable effect in runs of 50 feet (15 meters) or less in standard domestic loudspeaker connections for a typical 8 ohm speaker. [4] For aluminum or copper-clad aluminum wire, 14-gauge or heavier cable is needed to support this claim due to higher resistivity. [4]
It defines a new license-free, royalty-free, digital audio/video interconnect, intended to be used primarily between a computer and its display monitor, or a computer and a home-theater system. The video signal is not compatible with DVI or HDMI , but a DisplayPort connector can pass these signals through.
Apple proprietary. Combines Analog VGA out, stereo analog audio out, analog microphone in, S-video capture in, Apple desktop bus interface. Proprietary connector used on Apple Macintosh Centris computers, and the Apple AudioVision 14 Display. An attempt by Apple to deal with cable clutter, by combining five separate cables from computer to monitor.
Fig. 1 - Relationship between TL length and wavelength Fig. 2 - Frequency response (magnitude) measurement of drive unit and TL outputs. Phase inversion is achieved by selecting a length of line that is equal to the quarter wavelength of the target lowest frequency.
A Shure FP24 preamp's mono XLR line outputs connected to an Edirol R-09 recorder's 3.5mm stereo jack line input, using a Y-cable. This is an example of consolidating connectors, as described below. A Y-cable, Y cable, or splitter cable is a cable with three ends: one common end and two other ends. The Y-cable can resemble the Latin letter "Y".
A combined video/audio jack is also present on some computers; several generations of the Raspberry Pi have analog audio and video from the same jack, and Sony also used this style of connection as the TV-out on some models of Vaio laptop. Hands-free sets and headsets often use 3.5 mm or 2.5 mm connectors.
Varying cable quality means that a cheap line-level audio cable might not successfully transfer component video. For digital audio, as long as a connection is successfully made using the cables the sound will remain faithful to the original signal because a digital signal can only be fully received or not received at all. Cables should meet the ...
Line drivers are commonly used within digital systems, e.g. to communicate digital signals across circuit-board traces and cables. [ 1 ] In analog audio , a line driver is typically used to drive line-level analog signal outputs, for example to connect a CD player to an amplified speaker system.