enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Twin-lead - Wikipedia

    en.wikipedia.org/wiki/Twin-lead

    For this reason, when attaching a twin-lead line to a coaxial cable connection, such as the 300 Ω twin-lead from a domestic television antenna to the television's 75 ohm coax antenna input, a balun with a 4:1 ratio is commonly used. Its purpose is double: First, it transforms twin-lead's 300 Ω impedance to match the 75 Ω coaxial cable ...

  3. Television antenna - Wikipedia

    en.wikipedia.org/wiki/Television_antenna

    The antenna is connected to the television with a specialized cable designed to carry radio current, called transmission line. Earlier antennas used a flat cable called 300 ohm twin-lead . The standard today is 75 ohm coaxial cable , which is less susceptible to interference which plugs into an F connector or Belling-Lee connector (depending on ...

  4. Radio transmitter design - Wikipedia

    en.wikipedia.org/wiki/Radio_transmitter_design

    A radio transmitter or just transmitter is an electronic device which produces radio waves with an antenna. Radio waves are electromagnetic waves with frequencies between about 30 Hz and 300 GHz. The transmitter itself generates a radio frequency alternating current, which is applied to the antenna. When excited by this alternating current, the ...

  5. Impedance matching - Wikipedia

    en.wikipedia.org/wiki/Impedance_matching

    In radio-frequency (RF) systems, a common value for source and load impedances is 50 ohms. A typical RF load is a quarter-wave ground plane antenna (37 ohms with an ideal ground plane). The general form of the voltage reflection coefficient for a wave moving from medium 1 to medium 2 is given by

  6. Electrical termination - Wikipedia

    en.wikipedia.org/wiki/Electrical_termination

    A terminating resistor for a television coaxial cable is often in the form of a cap, threaded to screw onto an F connector. Antenna cables are sometimes used for internet connections; however, RG-6 should not be used for 10BASE2 (which should use RG-58) as the impedance mismatch can cause phasing problems with the baseband signal.

  7. Dipole antenna - Wikipedia

    en.wikipedia.org/wiki/Dipole_antenna

    The G5RV antenna is a dipole antenna fed indirectly, through a carefully chosen length of 300 Ω or 450 Ω twin lead, which acts as an impedance matching network to connect (through a balun) to a standard 50 Ω coaxial transmission line. The sloper antenna is a slanted vertical dipole antenna attached to the top of a single tower. The element ...

  8. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  9. Antenna amplifier - Wikipedia

    en.wikipedia.org/wiki/Antenna_amplifier

    In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...