Ad
related to: what is a 3.8 gps speed test for wifi signal strength
Search results
Results from the WOW.Com Content Network
Minimal received signal power of wireless network (802.11 variants) −111 dBm: 0.008 pW = 8 fW: Thermal noise floor for commercial GPS single-channel signal bandwidth (2 MHz) −127.5 dBm: 0.178 fW = 178 aW: Typical received signal power from a GPS satellite: −174 dBm: 0.004 aW = 4 zW: Thermal noise floor for 1 Hz bandwidth at room ...
Wi-Fi positioning system (WPS) is used where GPS is inadequate. The localization technique used for positioning with wireless access points is based on measuring the intensity of the received signal (received signal strength in English RSS) and the method of "fingerprinting".
Wi-Fi (/ ˈ w aɪ f aɪ /) [1] [a] is a family of wireless network protocols based on the IEEE 802.11 family of standards, which are commonly used for local area networking of devices and Internet access, allowing nearby digital devices to exchange data by radio waves.
The directional antenna's signal, termed a spot beam, is intended to be aimed at a specific region (i.e., several hundred kilometers in diameter) and increase the local signal strength by 20 dB (10× voltage field strength, 100× power). A side effect of having two antennas is that, for receivers inside the spot beam, the GPS satellite will ...
Since the speed of radio waves (speed of light) [78] is constant and independent of the satellite speed, the time delay between when the satellite transmits a signal and the ground station receives it is proportional to the distance from the satellite to the ground station. With the distance information collected from multiple ground stations ...
A Bluetooth earbud, an earphone and microphone that communicates with a cellphone using the Bluetooth protocol. Bluetooth is a short-range wireless technology standard that is used for exchanging data between fixed and mobile devices over short distances and building personal area networks (PANs).
GPS satellites are potential targets for jamming, [73] [74] but satellite phone and television signals have also been subjected to jamming. [ 75 ] [ 76 ] Also, it is very easy to transmit a carrier radio signal to a geostationary satellite and thus interfere with the legitimate uses of the satellite's transponder.
The formula is derived from the speed of light and the length of the sequence [citation needed]: M U R = ( c ∗ 0.5 ∗ T S P ) {\displaystyle MUR=\left(c*0.5*TSP\right)} where c is the speed of light , usually in metres per microsecond, and TSP is the addition of all the positions of the stagger sequence, usually in microseconds.
Ad
related to: what is a 3.8 gps speed test for wifi signal strength