Search results
Results from the WOW.Com Content Network
Input lag or input latency is the amount of time that passes between sending an electrical signal and the occurrence of a corresponding action.. In video games the term is often used to describe any latency between input and the game engine, monitor, or any other part of the signal chain reacting to that input, though all contributions of input lag are cumulative.
Generally a lag below 100 ms (10 hz or fps) is considered to be necessary for playability. The lowest ping physically possible for a connection between opposite points on Earth crossing half of the planet is 133 ms. Other causes of lag result commonly in a lag below a playable 20 ms (50 hz or fps), or in the loss, corruption or jitter of the game.
Screen tearing [1] is a visual artifact in video display where a display device shows information from multiple frames in a single screen draw. [ 2 ] The artifact occurs when the video feed to the device is not synchronized with the display's refresh rate.
This chart shows the most common display resolutions, with the color of each resolution type indicating the display ratio (e.g., red indicates a 4:3 ratio).
A poll message is a control-acknowledgment message.. In a multidrop line arrangement (a central computer and different terminals in which the terminals share a single communication line to and from the computer), the system uses a master/slave polling arrangement whereby the central computer sends message (called polling message) to a specific terminal on the outgoing line.
60 fps typically, some gaming monitors can do up to 540 fps; internally, display refreshed at up to 540 fps [18] [19] 60 fps typically, some can do 120 fps; internally, display refreshed at e.g. 480 or 600 fps [20] 60 fps typically. Up to 480 fps. [21] Flicker: Perceptible on lower refresh rates (60 fps and below) [22]
Frame rate up-conversion (FRC) is the process of increasing the temporal resolution of a video sequence by synthesizing one or more intermediate frames between two consecutive frames. A low frame rate causes aliasing, yields abrupt motion artifacts, and degrades the video quality. Consequently, the temporal resolution is an important factor ...
The rate of 120 was chosen as the least common multiple of 24 fps (cinema) and 30 fps (NTSC TV), and allows for less distortion when movies are viewed due to the elimination of telecine (3:2 pulldown). For PAL at 25 fps, 100 or 200 Hz is used as a fractional compromise of the least common multiple of 600 (24 × 25).