Search results
Results from the WOW.Com Content Network
A mattress topper is a thin mattress, usually 5–10 centimetres (2–4 in) thick. [citation needed] Stand-alone mattresses of this size exist (see futon and Bed base#Floor beds; traditional European beds were made of a stack of mattresses of this size).
The hose is then fit onto the barb, the clamp expanded again, slid onto the portion of the hose over the barb, then released, compressing the hose onto the barb. Clamps of this design are rarely used for high pressures or large hoses, as they would require unwieldy amounts of steel to generate enough clamping force, and be impossible to work ...
Chinese daybed from the Ming Dynasty. A daybed is an item of furniture used as a bed as well as for lounging, reclining, and seating in a common room. [1] It may be considered a form of multifunctional furniture. Their frames can be made out of wood, metal, or a combination of wood and metal. [2]
In practice, bed sizes are usually categorized by the width. The length is typically 200 cm (79 in), but this may vary. The most common sizes are: [citation needed] 120 cm × 200 cm (47 in × 79 in) 150 cm × 200 cm (59 in × 79 in) 180 cm × 200 cm (71 in × 79 in) Other bed sizes are available, which are less common however.
For a taper thread, it is the diameter at the "gauge length" (plus/minus one thread pitch) from the small end of the thread. The taper is 1:16, meaning that for each 16 units of measurement increase in the distance from the end, the diameter increases by 1 unit of measurement.
A 37° flare type end fitting for flexible hose The AN thread (also A-N ) is a particular type of fitting used to connect flexible hoses and rigid metal tubing that carry fluid. It is a US military-derived specification that dates back to World War II and stems from a joint standard agreed upon by the Army Air Corps and Navy, hence AN.
Hose link is a 1/4-turn bayonet-mount garden hose connection, which uses an o-ring to o-ring seal. It was designed by Hoselink, Pty, Ltd., Australia, [24] and patented in 1998. [25] It is popular in Australia, with limited distribution in the UK and the US, where it is distributed by Dayco Products, Inc.
A pipe clamp is a type of clamp often employed in piping, woodworking, and cabinet shops. Pipe clamps for woodwork or cabinet shops are usually composed of commercially manufactured clamp heads or "jaws" and a length of common threaded pipe. [1] [2] The capacity of the clamp is determined by the length of the pipe used.