enow.com Web Search

  1. Ads

    related to: electrical safety osha fact sheet excavation permit requirements

Search results

  1. Results from the WOW.Com Content Network
  2. Electrical safety standards - Wikipedia

    en.wikipedia.org/wiki/Electrical_safety_standards

    The electrical safety develops with the technical progress. In 1989 OSHA [1] promulgated a much-needed regulation in the General Industry Regulations. Several standards are defined for control of hazardous energy, or lockout/tagout. In 1995 OSHA was successful in promulgation of regulations for utility. [2]

  3. Hazardous energy - Wikipedia

    en.wikipedia.org/wiki/Hazardous_energy

    This booklet presents OSHA's general requirements for controlling hazardous energy during service or maintenance of machines or equipment. It is not intended to replace or to supplement OSHA standards regarding the control of hazardous energy. Health and Safety Executive, Electrical safety and you, a brief guide; Lockout/Tagout. OSHA Fact Sheet ...

  4. Electrical equipment in hazardous areas - Wikipedia

    en.wikipedia.org/wiki/Electrical_equipment_in...

    Unlike ATEX which uses numbers to define the safety "Category" of equipment (namely 1, 2, and 3), the IEC continued to utilise the method used for defining the safe levels of intrinsic safety namely "a" for zone 0, "b" for zone 1 and "c" for zone 2 and apply this Equipment Level of Protection to all equipment for use in hazardous areas since ...

  5. Occupational Safety and Health Act (United States) - Wikipedia

    en.wikipedia.org/wiki/Occupational_Safety_and...

    Section 8 permits OSHA inspectors to enter, inspect and investigate, during regular working hours, any workplace covered by the Act. [25] Employers must also communicate with employees about hazards in the workplace. By regulation, OSHA requires that employers keep a record of every non-consumer chemical product used in the workplace.

  6. Lockout–tagout - Wikipedia

    en.wikipedia.org/wiki/Lockout–tagout

    In industry this is an OSHA standard, as well as for electrical NFPA 70E. OSHA's standard on the Control of Hazardous Energy (Lockout-Tagout), found in 29 CFR 1910.147, [3] spells out the steps employers must take to prevent accidents associated with hazardous energy. The standard addresses practices and procedures necessary to disable ...

  7. Workplace safety standards - Wikipedia

    en.wikipedia.org/wiki/Workplace_Safety_Standards

    In the United States the first Federal Safety Standards for cars become effective 1 January 1968. These new standards help protect drivers against unreasonable risk of crashes occurring as a result of the design, construction or performance of motor vehicles. [5] In 2015 was created EFM scientist against EMF radiation.

  1. Ads

    related to: electrical safety osha fact sheet excavation permit requirements