Ads
related to: phillips screw drive specs
Search results
Results from the WOW.Com Content Network
The Phillips/square screw drive, also known as the Quadrex, Pozisquare screw drive, is a combination of the Phillips and Robertson screw drives. While a standard Phillips or Robertson tool can be used, there is also a dedicated tool for it that increases the surface area between the tool and the fastener so it can handle more torque.
Part of a series on: Screw drive types; Slotted; Slot drive; Cross; Cruciform; Frearson; French recess; ISO 8764; JIS B 1012; Mortorq; Phillips; Pozidriv; Supadriv ...
Comparison of Phillips and Frearson screw heads. Reed and Prince, also called Frearson, is another historic cross-head screw configuration. The cross in the screw head is sharper and less rounded than a Phillips, and the bit has 45° flukes and a sharper, pointed end. Also, the Phillips screw slot is not as deep as the Reed and Prince slot.
They may either have a Phillips flat head or a slotted hex washer head. Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole ...
On a shaft, this may be simply a flattened area. A set screw may have any type of drive, such as hex or square head, slot, or recessed --- cross (Phillips), hex (Allen), star (Torx), or square (Robertson). In the UK, the term "set screw" or "setscrew" refers simply to a bolt which is fully threaded, with no smooth shank; called cap screw in the US.
The design of the recess and how it works. The aesthetic design points were added to it. The different recess sizes that are available. Then I added a quality assurance section talking about the Phillips Screw Company quality control of this drive system Richyrich1776 17:44, 21 September 2022 (UTC)
Ads
related to: phillips screw drive specs