Ads
related to: baseband vs broadband ethernet
Search results
Results from the WOW.Com Content Network
A baseband channel or lowpass channel (or system, or network) is a communication channel that can transfer frequencies that are very near zero. [4] Examples are serial cables and local area networks (LANs), as opposed to passband channels such as radio frequency channels and passband filtered wires of the analog telephone network.
The Broadband Integrated Services Digital Network (B-ISDN) was designed for these needs. [13] The types of traffic supported by a broadband network can be classified according to three characteristics: [14] Bandwidth is the amount of network capacity required to support a connection. Latency is the amount of delay associated with a connection.
Through the first half of the 1980s, Ethernet's 10BASE5 implementation used a coaxial cable 0.375 inches (9.5 mm) in diameter, later called thick Ethernet or thicknet. Its successor, 10BASE2, called thin Ethernet or thinnet, used the RG-58 coaxial cable. The emphasis was on making installation of the cable easier and less costly.
The physical-layer specifications of the Ethernet family of computer network standards are published by the Institute of Electrical and Electronics Engineers (IEEE), which defines the electrical or optical properties and the transfer speed of the physical connection between a device and the network or between network devices.
According to the most common definition of a digital signal, both baseband and passband signals representing bit-streams are considered as digital transmission, while an alternative definition only considers the baseband signal as digital, and passband transmission of digital data as a form of digital-to-analog conversion. [citation needed]
In telecommunications engineering, this is a broadband signaling technique. [a] Broadband provides several advantages over the baseband signal used, for instance in 10BASE5. Range is greatly extended (3,600 m (11,800 ft), versus 500 m (1,600 ft) for 10BASE5), and multiple signals can be carried on the same cable. 10BROAD36 can even share a ...
A 100BASE-TX transmitter sends three differential voltages, +1 V, 0 V, or −1 V. [15] Unlike earlier Ethernet standards using broadband and coaxial cable, such as 10BASE5 (thicknet) and 10BASE2 (thinnet), 10BASE-T does not specify the exact type of wiring to be used but instead specifies certain characteristics that a cable must meet. This was ...
3Com 3C905B-TX 100BASE-TX PCI network interface card. 100BASE-TX is the predominant form of Fast Ethernet, and runs over two pairs of wire inside a Category 5 or above cable. Cable distance between nodes can be up to 100 metres (328 ft). One pair is used for each direction, providing full-duplex operation at 100 Mbit/s in each direction.
Ads
related to: baseband vs broadband ethernet