Search results
Results from the WOW.Com Content Network
For example, an 8-to-1 multiplexer can be made with two 4-to-1 and one 2-to-1 multiplexers. The two 4-to-1 multiplexer outputs are fed into the 2-to-1 with the selector pins on the 4-to-1's put in parallel giving a total number of selector inputs to 3, which is equivalent to an 8-to-1.
This yields S = B + A + 1, which is easy to do with a slightly modified adder. By preceding each A input bit on the adder with a 2-to-1 multiplexer where: Input 0 (I 0) is A; Input 1 (I 1) is A; that has control input D that is also connected to the initial carry, then the modified adder performs addition when D = 0, or; subtraction when D = 1.
One way to implement a barrel shifter is as a sequence of multiplexers where the output of one multiplexer is connected to the input of the next multiplexer in a way that depends on the shift distance. A barrel shifter is often used to shift and rotate n-bits in modern microprocessors, [1] typically within a single clock cycle.
2 dual 4-line to 1-line FET multiplexer / demultiplexer (16) SN74CBT3253: 74x3257 4 quad 2-line to 1-line FET multiplexer / demultiplexer (16) IDT74FST3257: 74x3283 1 32-bit latchable transceiver with parity checker / generator three-state (120) 74ACTQ3283: 74x3284 1 18-bit synchronous datapath multiplexer three-state (100) 74ABT3284: 74x3305 2
The carry-out signal from the second full adder ()would drive the select signal for three 2 to 1 multiplexers. The second set of 2 full adders would add the last two bits assuming is a logical 0. And the final set of full adders would assume that is a logical 1.
A full adder can be viewed as a 3:2 lossy compressor: it sums three one-bit inputs and returns the result as a single two-bit number; that is, it maps 8 input values to 4 output values. (the term "compressor" instead of "counter" was introduced in [13])Thus, for example, a binary input of 101 results in an output of 1 + 0 + 1 = 10 (decimal ...
Here we show an adder with block sizes of 2-2-3-4-5, this is the special type of Variable-sized carry select adder, called as square root carry select adder. [2] This break-up is ideal when the full-adder delay is equal to the MUX delay, which is unlikely. The total delay is two full adder delays, and four mux delays.
A binary multiplier is an electronic circuit used in digital electronics, such as a computer, to multiply two binary numbers.. A variety of computer arithmetic techniques can be used to implement a digital multiplier.