Search results
Results from the WOW.Com Content Network
Bulk density is not the same as the particle density, which is an intrinsic property of the solid and does not include the volume for voids between particles (see: density of non-compact materials). Bulk density is an extrinsic property of a material; it can change depending on how the material is handled. For example, a powder poured into a ...
The bulk volume of a material —inclusive of the void space fraction— is often obtained by a simple measurement (e.g. with a calibrated measuring cup) or geometrically from known dimensions. Mass divided by bulk volume determines bulk density. This is not the same thing as the material volumetric mass density.
The bulk modulus (or or ) of a substance is a measure of the resistance of a substance to bulk compression. It is defined as the ratio of the infinitesimal pressure increase to the resulting relative decrease of the volume .
Particle density is in contrast to the bulk density, which measures the average density of a large volume of the powder in a specific medium (usually air). The particle density is a relatively well-defined quantity, as it is not dependent on the degree of compaction of the solid, whereas the bulk density has different values depending on ...
Alternatively, it may be defined as SA per solid or bulk volume [2] [3] (units of m 2 /m 3 or m −1). It is a physical value that can be used to determine the type and properties of a material (e.g. soil or snow). It has a particular importance for adsorption, heterogeneous catalysis, and reactions on surfaces.
where is the void ratio, is the porosity, V V is the volume of void-space (gases and liquids), V S is the volume of solids, and V T is the total (or bulk) volume. This figure is relevant in composites , in mining (particular with regard to the properties of tailings ), and in soil science .
where V V is the volume of void-space (such as fluids) and V T is the total or bulk volume of material, including the solid and void components. Both the mathematical symbols ϕ {\displaystyle \phi } and n {\displaystyle n} are used to denote porosity.
Finally, a very general limitation of this type of equation of state is their inability to take into account the phase transitions induced by the pressure and temperature of melting, but also multiple solid-solid transitions that can cause abrupt changes in the density and bulk modulus based on the pressure. [3]