Search results
Results from the WOW.Com Content Network
Open emitter output exposes the emitter as the output. [2] For an NPN open emitter output, the collector is connected to the positive voltage rail, so the emitter outputs a high voltage when the transistor is on and is hi-Z when off. For a PNP open emitter output, the collector is connected to the low voltage supply, so the emitter outputs a ...
A common example is connecting localized decoupling capacitors close to the power leads of integrated circuits to suppress coupling via the power supply connections. These act as a small localized energy reservoir that supply the circuit with current during transient , high current demand periods, preventing the voltage on the power supply rail ...
Low-dropout (LDO) regulators operate similarly to all linear voltage regulators.The main difference between LDO and non-LDO regulators is their schematic topology.Instead of an emitter follower topology, low-dropout regulators consist of an open collector or open drain topology, where the transistor may be easily driven into saturation with the voltages available to the regulator.
The transistor continuously monitors V diff and adjusts its emitter voltage to equal V in minus the mostly constant V BE (approximately one diode forward voltage drop) by passing the collector current through the emitter resistor R E. As a result, the output voltage follows the input voltage variations from V BE up to V +; hence the name ...
Emitter bias. When a split supply (dual power supply) is available, this biasing circuit is the most effective. It provides zero bias voltage at the emitter or collector for load. [clarification needed] The negative supply V ee is used to forward-bias the emitter junction through R e. The positive supply V cc is used to reverse-bias the ...
The emitter is of heavily-doped p-type material. The single PN junction between the emitter and the base gives the device its name. The resistance between B1 and B2 when the emitter is open-circuit is called interbase resistance. The emitter junction is usually located closer to base-2 (B2) than base-1 (B1) so that the device is not symmetrical ...
Log in to your AOL account to access email, news, weather, and more.
In switch-mode power supplies, the control circuits are powered from the output. To start the power supply, a leakage resistance can be used to trickle-charge the supply rail for the control circuit to start it oscillating. This approach is less costly and simpler than providing a separate linear power supply just to start the regulator circuit ...