enow.com Web Search

  1. Ads

    related to: steel buildings cost per square foot

Search results

  1. Results from the WOW.Com Content Network
  2. List of most expensive buildings - Wikipedia

    en.wikipedia.org/wiki/List_of_most_expensive...

    Asia Square: Singapore Singapore: Denton Corker Marshall with Architects61 CapitaLand Integrated Commercial Trust, Qatar Investment Authority 2013 4.06 [14] [15] 4.49 Suntec City: Singapore Singapore: I. M. Pei with DP Architects and Tsao & McKown Architects: Suntec REIT 1997 3.81 [16] 3.81 One World Trade Center: New York City United States

  3. U.S. Steel Tower - Wikipedia

    en.wikipedia.org/wiki/U.S._Steel_Tower

    The U.S. Steel Tower, also known as the Steel Building, or USX Tower (1988–2001), is a 64-story skyscraper at 600 Grant Street in downtown Pittsburgh, Pennsylvania. The interior has 2,300,000 sq ft (210,000 m 2) of leasable space. At 256.3 m (841 ft) tall, it is the tallest building in Pittsburgh. [10]

  4. How Much Does It Cost To Build a House? - AOL

    www.aol.com/much-does-cost-build-house-210010797...

    General contractor cost: 10% to 20% of the total project cost. House framer rate: $7 to $16 per square foot. Interior designer rate: $50 to $200 per hour. Landscape architect fee: $70 to $150 per ...

  5. Empire State Building - Wikipedia

    en.wikipedia.org/wiki/Empire_State_Building

    The structural steel was pre-ordered and pre-fabricated in anticipation of a revision to the city's building code that would have allowed the Empire State Building's structural steel to carry 18,000 pounds per square inch (120,000 kPa), up from 16,000 pounds per square inch (110,000 kPa), thus reducing the amount of steel needed for the building.

  6. Construction of the World Trade Center - Wikipedia

    en.wikipedia.org/wiki/Construction_of_the_World...

    The thickness of the plates and grade of structural steel varied over the height of the tower, ranging from 36,000 to 100,000 pounds per square inch (260 to 670 MPa). [a] The thickness of the steel plates decreased with height because they were required to support lesser amounts of building mass and wind loads on higher floors. [102]

  7. Self-framing metal buildings - Wikipedia

    en.wikipedia.org/wiki/Self-Framing_Metal_Buildings

    Buildings should be designed for all applicable loads including the following: Dead (self-weight) loads including mechanical and electrical components. Vertical live load of the building will be not less than (per local code) pounds per square foot applied on the horizontal projection of the roof.

  1. Ads

    related to: steel buildings cost per square foot