enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Sound reinforcement system - Wikipedia

    en.wikipedia.org/wiki/Sound_reinforcement_system

    Using a crossover to separate the sound into low, middle and high frequencies can lead to a "cleaner", clearer sound (see bi-amplification) than routing all of the frequencies through a single full-range speaker system. Nevertheless, many small venues still use a single full-range speaker system, as it is easier to set up and less expensive.

  3. Motorboating (electronics) - Wikipedia

    en.wikipedia.org/wiki/Motorboating_(electronics)

    Then, after a delay time set by the circuit's time constant, the circuit increases the gain again until the amplitude of the radio signal triggers another gain reduction. This repetitive cycle is heard as motorboating. An example might be a 27 MHz Citizen's band radio in a car, connected to the car's 12 volt DC supply.

  4. Loudspeaker - Wikipedia

    en.wikipedia.org/wiki/Loudspeaker

    The term loudspeaker may refer to individual transducers (also known as drivers) or to complete speaker systems consisting of an enclosure and one or more drivers.. To adequately and accurately reproduce a wide range of frequencies with even coverage, most loudspeaker systems employ more than one driver, particularly for higher sound pressure level (SPL) or maximum accuracy.

  5. Bass reflex - Wikipedia

    en.wikipedia.org/wiki/Bass_reflex

    Bass reflex enclosure schematic (cross-section). RCA bass reflex shelf stereo speakers.. A bass reflex system (also known as a ported, vented box or reflex port) is a type of loudspeaker enclosure that uses a port (hole) or vent cut into the cabinet and a section of tubing or pipe affixed to the port.

  6. Electrodynamic speaker driver - Wikipedia

    en.wikipedia.org/wiki/Electrodynamic_speaker_driver

    All speaker drivers have a means of electrically inducing back-and-forth motion. Typically there is a tightly wound coil of insulated wire (known as a voice coil) attached to the neck of the driver's cone. In a ribbon speaker, the voice coil may be printed or bonded onto a sheet of very thin paper, aluminum, fiberglass or plastic.

  7. Passive radiator (speaker) - Wikipedia

    en.wikipedia.org/wiki/Passive_radiator_(speaker)

    The middle speaker is a real loudspeaker. The top and bottom cones are passive radiators. In the same way as a ported loudspeaker, a passive radiator system uses the sound pressure otherwise trapped in the enclosure to excite a resonance that makes it easier for the speaker system to create the deepest pitches (e.g., basslines). The passive ...

  8. U.S. October budget deficit jumps to $257 billion, handing ...

    www.aol.com/news/u-october-budget-deficit-jumps...

    WASHINGTON (Reuters) -The U.S. budget deficit jumped nearly four-fold to $257 billion in October, a figure inflated by one-off factors, the Treasury Department said on Wednesday in a report that ...

  9. Stage monitor system - Wikipedia

    en.wikipedia.org/wiki/Stage_monitor_system

    A stage monitor system is a set of performer-facing loudspeakers called monitor speakers, stage monitors, floor monitors, wedges, or foldbacks on stage during live music performances in which a sound reinforcement system is used to amplify a performance for the audience. The monitor system allows musicians to hear themselves and fellow band ...