enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hole saw - Wikipedia

   en.wikipedia.org/wiki/Hole_saw

   Tungsten carbide hole saw with arbor A 52 mm (2.0 in) hole saw with pilot bit A 115 mm (4.5 in) diamond hole saw. A hole saw (also styled holesaw), also known as a hole cutter, [1] is a saw blade of annular (ring) shape, whose annular kerf creates a hole in the workpiece without having to cut up the core material.

3. Bore Through Tough Concrete and Brick With These Masonry ...

   www.aol.com/lifestyle/bore-tough-concrete-brick...

   Hole Saw: For cutting large holes through extra-hard material like granite or ... These 3/16-inch Bosch bits are the perfect size for drilling pilot holes for ¼-inch Tapcon concrete screws, and ...

4. Router (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_(woodworking)

   Bits also differ by the diameter of their shank, with 1 ⁄ 2-inch, 12 mm, 10 mm, 3 ⁄ 8-inch, 8 mm and 1 ⁄ 4-inch and 6 mm shanks (ordered from thickest to thinnest) being the most common. Half-inch bits cost more but, being stiffer, are less prone to vibration (giving smoother cuts) and are less likely to break than the smaller sizes.

5. Annular cutter - Wikipedia

   en.wikipedia.org/wiki/Annular_cutter

   An annular cutter, named after the annulus shape, cuts only a groove at the periphery of the hole and leaves a solid core or slug at the center. [1] An annular cutter is a more expensive and efficient alternative to spiral drill bits and standard hole saws. An annular cutter is similar to a hole saw but differs in geometry and material.

6. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   1.25 in (32 mm) hole saw bit. Hole saws take the form of a short open cylinder with saw-teeth on the open edge, used for making relatively large holes in thin material. They remove material only from the edge of the hole, cutting out an intact disc of material, unlike many drills which remove all material in the interior of the hole.

7. Disc cutter - Wikipedia

   en.wikipedia.org/wiki/Disc_cutter

   For long straight cuts on sheet metal or for light cut-off work, a standard circular saw is used with a 7 + 1 ⁄ 4-inch cutting wheel. These cutting discs are made just like the smaller wheels of an angle grinder, with resin bonded abrasive material, or are of metal with a diamond-coated edge.