enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Leak-down tester - Wikipedia

   en.wikipedia.org/wiki/Leak-down_tester

   The input pressure is set for 80 psi (550 kPa), and 60 psi (410 kPa) minimum cylinder pressure is the accepted standard. While the leak-down tester pressurizes the cylinder, the mechanic can listen to various parts to determine where any leak may originate.

3. Hydrostatic test - Wikipedia

   en.wikipedia.org/wiki/Hydrostatic_test

   A hydrostatic test is a way in which pressure vessels such as pipelines, plumbing, gas cylinders, boilers and fuel tanks can be tested for strength and leaks. The test involves filling the vessel or pipe system with a liquid, usually water, which may be dyed to aid in visual leak detection , and pressurization of the vessel to the specified ...

4. Pressure measurement - Wikipedia

   en.wikipedia.org/wiki/Pressure_measurement

   Leak testing; A pressure sensor may be used to sense the decay of pressure due to a system leak. This is commonly done by either comparison to a known leak using differential pressure, or by means of utilizing the pressure sensor to measure pressure change over time. Groundwater measurement; Above-ground casing of a piezometer Symbol used in ...

5. Air flow bench - Wikipedia

   en.wikipedia.org/wiki/Air_flow_bench

   H, pressure drop across test piece in pascals measured by the test pressure manometer d , density of air in kilograms per cubic meter ( 1.20 kilograms per cubic meter at standard conditions ) This represents the highest speed of the air in the flow path of a normally shaped port, at or near the section of minimum area ( through the valve seat ...

6. Flow measurement - Wikipedia

   en.wikipedia.org/wiki/Flow_measurement

   The Dall tube is a shortened version of a Venturi meter, with a lower pressure drop than an orifice plate. As with these flowmeters the flow rate in a Dall tube is determined by measuring the pressure drop caused by restriction in the conduit. The pressure differential is typically measured using diaphragm pressure transducers with digital readout.

7. Testing and inspection of diving cylinders - Wikipedia

   en.wikipedia.org/wiki/Testing_and_inspection_of...

   A hydrostatic test involves pressurising the cylinder to its test pressure (usually 5/3 or 3/2 of the working pressure) and measuring its volume before and after the test. A permanent increase in volume above the tolerated level means the cylinder fails the test and must be permanently removed from service. [3]: sect. 5.7.3