Search results
Results from the WOW.Com Content Network
When a plug is inserted, the isolated switch inside the jack informs the motherboard, and the codec sends audio to the headphones. A similar isolated switch is used to detect when a microphone has been plugged in. HD Audio can also sense the presence of an audio dongle. A 10 kΩ pull-up resistor is attached to pin 4 (PRESENCE#). When the HDA ...
PC Guide color lime green. Line outputs usually present a source impedance of from 100 to 600 ohms. The voltage can reach 2 volts peak-to-peak with levels referenced to −10 dBV (300 mV) at 10 kΩ. The frequency response of most modern equipment is advertised as at least 20 Hz to 20 kHz, which corresponds to the range of human hearing. Line ...
General 3.5 mm computer headsets come with two 3.5 mm connectors: one connecting to the microphone jack and one connecting to the headphone/speaker jack of the computer. 3.5 mm computer headsets connect to the computer via a sound card, which converts the digital signal of the computer to an analog signal for the headset. USB computer headsets ...
Headphone and earphone jacks on a wide range of equipment. 6.35 mm (1 ⁄ 4 in) plugs are common on home and professional audio equipment, while 3.5 mm plugs are nearly universal for portable audio equipment and headphones. 2.5 mm plugs are not as common, but are used on communication equipment such as cordless phones, mobile phones, and two ...
The USB OTG and Embedded Host Supplement to the USB 2.0 specification introduced three new communication protocols: . Attach Detection Protocol (ADP): Allows an OTG device, embedded host or USB device to determine attachment status in the absence of power on the USB bus, enabling both insertion-based behavior and the capability to display attachment status.
The unit is then checked, but no anomaly is detected by the maintainer. Consequently, the unit is returned to service with no repair performed. [1] [2] [3] If there is an underlying fault that has not been detected the unit may be returned for repair several times with no fault identified. Alternative descriptors include: [4] No fault found (NFF)
While a loudspeaker must use a relatively large (often 15" or 18") speaker driver to reproduce low frequencies, headphones can accurately reproduce bass and sub-bass frequencies with speaker drivers only 40-50 millimeters wide (or much smaller, as is the case with in-ear monitor headphones). Headphones' impressive low-frequency performance is ...
USB-C, or USB Type-C, is a 24-pin, reversible connector (not a protocol) that supersedes previous USB connectors and can carry audio, video, and other data, to connect to monitors, external drives, hubs/docking stations, mobile phones, and many more peripheral devices. It can also provide and receive power, to power, e.g., a laptop or a mobile ...