enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Registered jack - Wikipedia

   en.wikipedia.org/wiki/Registered_jack

   A cable with a 50-pin connector on one end can support six fully wired 8P8C connectors or Ethernet ports on a patch panel with one spare pair. Alternatively, only the necessary pairs for 10/100 Ethernet can be wired allowing twelve Ethernet ports with a single spare pair. This connector is also used with spring bail locks for SCSI-1 connections.

3. Telephone jack and plug - Wikipedia

   en.wikipedia.org/wiki/Telephone_jack_and_plug

   For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...

4. Punch down tool - Wikipedia

   en.wikipedia.org/wiki/Punch_down_tool

   A punch down tool, punchdown tool, IDC tool, or a Krone tool (named after the Krone LSA-PLUS connector), is a small hand tool used by telecommunication and network technicians. It is used for inserting wire into insulation-displacement connectors on punch down blocks, patch panels, keystone modules, and surface mount boxes (also known as ...

5. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   The first types of small modular telephone connectors were created by AT&T in the mid-1960s for the plug-in handset and line cords of the Trimline telephone. [1] Driven by demand for multiple sets in residences with various lengths of cords, the Bell System introduced customer-connectable part kits and telephones, sold through PhoneCenter stores in the early 1970s. [2]

6. Keystone module - Wikipedia

   en.wikipedia.org/wiki/Keystone_module

   Some keystones use a pass-through type connector, where there is a jack on both the front face and the rear side. Others only have a jack on the front and employ a different mechanism for hard-wiring signal cables to the rear, such as a mini 110 block , an insulation-displacement connector , or a crimp or solder connection.

7. Push–pull connector - Wikipedia

   en.wikipedia.org/wiki/Push–pull_connector

   The push–pull connector is a type of cable interconnect that provides a strong locking mechanism that is only released by squeezing the connector body, thus preventing accidental disconnects. The connector is cylindrical, enabling a wide range of body styles and configurations such as low or high voltage multipin, coaxial, triaxial, fluid and ...