enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Chevrolet small-block engine (first- and second-generation)

   en.wikipedia.org/wiki/Chevrolet_small-block...

   The interchangeable parts include the rotating assembly (crank shaft, pistons, connecting rods, and flywheel/flex-plate) one piece rear main seal housing, oil pan and valve cover gaskets and valvetrain assembly (not including timing set, which includes a gear to drive the water pump). The LT1 uses a new engine block, cylinder head, timing cover ...

3. Chevrolet big-block engine - Wikipedia

   en.wikipedia.org/wiki/Chevrolet_big-block_engine

   The engine block had 4.84-inch (123 mm) bore centers, two-bolt main bearing caps, a "side oiling" lubrication system (the main oil gallery located low on the driver's side of the crankcase), with full-flow oil filter, and interchangeable cylinder heads. Heads used on the high performance 409 and 427 engines had larger ports and valves than ...

4. Chevrolet small-block engine - Wikipedia

   en.wikipedia.org/wiki/Chevrolet_small-block_engine

   The Chevrolet small-block engine refers to one of the several gasoline-powered vehicle engines manufactured by General Motors. These include: The first or second generation of non-LS Chevrolet small-block engines; The third, fourth, or fifth generation of LS-based GM engines; The Chevrolet Gemini small-block engine

5. Head gasket - Wikipedia

   en.wikipedia.org/wiki/Head_gasket

   In an internal combustion engine, a head gasket provides the seal between the engine block and cylinder head(s). Its purpose is to seal the combustion gases within the cylinders and to avoid coolant or engine oil leaking into the cylinders. [1] Leaks in the head gasket can cause poor engine running and/or overheating.

6. Hydrostatic seal - Wikipedia

   en.wikipedia.org/wiki/Hydrostatic_seal

   The second hydrostatic seal was an attempt to resolve first generation hydrostatic seal problems: erosion of seals, high pressure build up, and stagnant fluids. Second generation hydrostatic seals had a redesigned seal face; new face control grooves were added to help stabilize the seals while under extreme conditions.

7. Chevrolet Stovebolt engine - Wikipedia

   en.wikipedia.org/wiki/Chevrolet_Stovebolt_engine

   The Chevrolet Stovebolt engine is a straight-six engine made in two versions between 1929 and 1962 by the Chevrolet Division of General Motors.It replaced the company's 171-cubic-inch (2.8 L) inline-four as their sole engine offering from 1929 through 1954, and was the company's base engine starting in 1955 when it added the small block V8 to the lineup.