enow.com Web Search

  1. Ads

    related to: fluke amp tester

Search results

  1. Results from the WOW.Com Content Network
  2. Current clamp - Wikipedia

    en.wikipedia.org/wiki/Current_clamp

    An electrical meter with integral AC current clamp is known as a clamp meter, clamp-on ammeter, tong tester, or colloquially as an amp clamp. A clamp meter measures the vector sum of the currents flowing in all the conductors passing through the probe, which depends on the phase relationship of the currents. Only one conductor is normally ...

  3. Fluke Corporation - Wikipedia

    en.wikipedia.org/wiki/Fluke_Corporation

    Fluke purchased the testing and measurements division of Philips in 1993 for $41.8 million. [2] The Philips PM series of measurement instruments was rebranded as Fluke. Fluke was bought by the Danaher Corporation in 1998. Danaher spun off several subsidiaries, including Fluke, in 2016 to create Fortive. [3]

  4. Punch down tool - Wikipedia

    en.wikipedia.org/wiki/Punch_down_tool

    A punch down tool with interchangeable blades. A punch down tool, punchdown tool, IDC tool, or a Krone tool (named after the Krone LSA-PLUS connector), is a small hand tool used by telecommunication and network technicians.

  5. Multimeter - Wikipedia

    en.wikipedia.org/wiki/Multimeter

    Testing often requires that the component under test be isolated from the circuit in which they are mounted, as otherwise stray or leakage current paths may distort measurements. In some cases, the voltage from the multimeter may turn active devices on, distorting a measurement, or in extreme cases even damage an element in the circuit being ...

  6. Continuity test - Wikipedia

    en.wikipedia.org/wiki/Continuity_test

    In electronics, a continuity test is the checking of an electric circuit to see if current flows (that it is in fact a complete circuit). A continuity test is performed by placing a small voltage (wired in series with an LED or noise-producing component such as a piezoelectric speaker ) across the chosen path.

  7. Solenoid voltmeter - Wikipedia

    en.wikipedia.org/wiki/Solenoid_voltmeter

    When testing power supply circuits, a high-impedance connection (that is, a nearly open-circuit fault such as a burned switch contact or wire joint) in the power path might still allow enough voltage/current through to register on a high-impedance digital voltmeter, but it probably can't actuate the solenoid voltmeter. For use with high ...

  1. Ads

    related to: fluke amp tester