Ad
related to: tongue and groove easy hanger
Search results
Results from the WOW.Com Content Network
Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles
Matchboard by definition is "a board with a groove cut along one edge and a tongue along the other so as to fit snugly with the edges of similarly cut boards." [1]Bramble Cottage on Lundy Island, weathered cedar matchboarding in an exposed location
Originally developed as a blacksmiths tool, patented in 1899 Canada under CA64246A [4] by Vernon Graham Higgins and sold out of Fortuna, California by the patentee. . Advertised in the November 1899 issue of "The Blacksmith and Wheelwright", [5] an American periodical; the original variants had longer reins than the modern equivalent, and may not have had the groves in
A flooring clamp is used for holding tongue and groove flooring while individual boards are being face nailed. Up to 8 to 10 boards may be clamped at a time. A minimum of two are required; more is the norm. Spaced say every 4th or 5th joist.
In woodworking and construction, a nail is a small object made of metal (or wood, called a tree nail or "trunnel") which is used as a fastener, as a peg to hang something, or sometimes as a decoration. [1]
Groove joint: Like the dado joint, except that the slot is cut with the grain. Sometimes referred to interchangeably with the dado joint. Tongue and groove: Each piece has a groove cut all along one edge, and a thin, deep ridge (the tongue) on the opposite edge. If the tongue is unattached, it is considered a spline joint. Birdsmouth joint
Taylor Swift showed her generosity by tipping a group of service workers at the Grammys.. The Fortnight singer, who was nominated for six awards, was filmed handing a tip to staff before leaving ...
Also known simply as a pull lap, it is the basic form of the lap joint and is used when joining members end to end either parallel or at right angles.When the joint forms a corner, as in a rectangular frame, the joint is often called a corner lap.
Ad
related to: tongue and groove easy hanger