Search results
Results from the WOW.Com Content Network
An unmounted resistive foil strain gauge. A strain gauge takes advantage of the physical property of electrical conductance and its dependence on the conductor's geometry. . When an electrical conductor is stretched within the limits of its elasticity such that it does not break or permanently deform, it will become narrower and longer, which increases its electrical resistance end-to-
A strain gauge sensor measures the deformation of the elastic element, and the output of the sensor is converted by an electronic circuit to a signal that represents the load. Capacitive strain gauges measure the deformation of the elastic material using the change in capacitance of two plates as the plates move closer to each other.
A single resistor may be used, or a pair (half bridge), or four resistors connected in a Wheatstone bridge configuration. The strain resistor is bonded with adhesive to an object that is subjected to mechanical strain. With the strain gauge and a filter, amplifier, and analog/digital converter, the strain on an object can be measured.
Through a mechanical arrangement, the force being sensed deforms a strain gauge. The strain gauge converts the deformation to electrical signals. A load cell usually consists of four strain gauges in a Wheatstone bridge configuration. Load cells of one strain gauge (quarter bridge) or two strain gauges (half bridge) are also available.
A Wheatstone bridge is an electrical circuit used to measure an unknown electrical resistance by balancing two legs of a bridge circuit, one leg of which includes the unknown component. The primary benefit of the circuit is its ability to provide extremely accurate measurements (in contrast with something like a simple voltage divider ). [ 1 ]
The specimen is placed on the work table and a notch is created exactly at the centre. The crack should be generated such that the defect length is about half the depth. The load applied on the specimen is generally a three-point bending load. A type of strain gauge called a crack-mouth clip gage is used to measure the crack opening. [3]
Gauge factor (GF) or strain factor of a strain gauge is the ratio of relative change in electrical resistance R, to the mechanical strain ε. The gauge factor is defined as: [ 1 ] G F = Δ R / R Δ L / L = Δ R / R ε = 1 + 2 ν + Δ ρ / ρ ε {\displaystyle GF={\frac {\Delta R/R}{\Delta L/L}}={\frac {\Delta R/R}{\varepsilon }}=1+2\nu +{\frac ...
Through a mechanical arrangement, the torque being sensed deforms a strain gauge. The strain gauge converts the deformation to electrical signals. A torque transducer usually consists of four strain gauges in a Wheatstone bridge configuration. Torque transducers of one or two strain gauges are also available.