enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Push-to-pull compression fittings - Wikipedia

   en.wikipedia.org/wiki/Push-to-pull_compression...

   There was a reusable fitting that could be unscrewed and a slimmer single-use fitting which could not. A new grab washer was required each time if a joint was reused. The fittings were designed for use with polybutylene pipe, while stainless steel pipe inserts were used for internal support. Hepworth was acquired by Wavin in 2005. [1]

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   [21]: 149 Instead, pipe and fittings with plain (non-belled) connections are butted against each other, and clamped with special rubber sleeve (or "no-hub") fittings. [18]: 71 The rubber sleeves are typically secured with stainless steel worm drive clamping bands, which compress the rubber to make a tight seal around the pipes and fittings.

4. Nipple (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Nipple_(plumbing)

   ASTM A733-03 Standard Specification for Welded and Seamless Carbon Steel and Austenitic Stainless Steel Pipe Nipples. ASTM B687-99(2005)e1 Standard Specification for Brass, Copper, and Chromium-Plated Pipe Nipples. ASME B1.20.7 Hose Coupling Screw Threads, Inch.

5. Bunnings - Wikipedia

   en.wikipedia.org/wiki/Bunnings

   Bunnings Group Limited, trading as Bunnings Warehouse or Bunnings, is an Australian household hardware and garden centre chain. [2] The chain has been owned by Wesfarmers since 1994, and has stores in Australia and New Zealand.

6. Plumbing - Wikipedia

   en.wikipedia.org/wiki/Plumbing

   In addition to lengths of pipe or tubing, pipe fittings such as valves, elbows, tees, and unions. are used in plumbing systems. [40] Pipe and fittings are held in place with pipe hangers and strapping. Plumbing fixtures are exchangeable devices that use water and can be connected to a building's plumbing system. They are considered to be ...

7. Copper tubing - Wikipedia

   en.wikipedia.org/wiki/Copper_tubing

   While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 3 ⁄ 4 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...