Search results
Results from the WOW.Com Content Network
Propellant is burned in a gas generator (or "preburner") and the resulting hot gas is used to power the propellant pumps before being exhausted overboard and lost. Because of this loss, this type of engine is termed open cycle. The gas generator cycle exhaust products pass over the turbine first. Then they are expelled overboard.
In a simple cycle gas-turbine, also known as open-cycle gas-turbine (OCGT) generators, hot gas drives a gas turbine to generate electricity. This type of plant is relatively cheap to build and can start very quickly, but due to its lower efficiency is at most only run for a few hours a day as a peaking power plant. [8]
The basic operation of the gas turbine is a Brayton cycle with air as the working fluid: atmospheric air flows through the compressor that brings it to higher pressure; energy is then added by spraying fuel into the air and igniting it so that the combustion generates a high-temperature flow; this high-temperature pressurized gas enters a ...
One is the Joule or Brayton cycle which is a gas turbine cycle and the other is the Rankine cycle which is a steam turbine cycle. [5] The cycle 1-2-3-4-1 which is the gas turbine power plant cycle is the topping cycle. It depicts the heat and work transfer process taking place in the high temperature region.
A simple-cycle combustion turbine (SCCT) is a type of gas turbine typically used in the power generation, aviation , and oil and gas industries (for electricity generation and mechanical drives). The simple-cycle combustion turbine follows the Brayton Cycle and differs from a combined cycle operation in that it has only one power cycle (i.e. no ...
The gas turbine cycle is used for all modern gas turbine and turbojet engines, however simple cycle turbines are often recuperated to improve efficiency and these recuperated turbines more closely resemble Ericsson's work. Ericsson eventually abandoned the open cycle in favor of the traditional closed Stirling cycle.
The LMS100 PA produces approximately 100 MW at an efficiency of around 46% LHV in open cycle operation. It is currently the largest and most efficient aero-derivative gas turbine. It is able to produce full rated power in under 10 minutes. [citation needed] The LMS100 comprises a low-pressure compressor, an intercooler, a supercore and a power ...
Didcot OCGT is an Open Cycle Gas Turbine that was originally part of Didcot A. Built in 1968, it uses four open-cycle gas turbines, which are each powered by a pair of Rolls-Royce Avon engines to generate 100 MW of electricity. [50] The site was made separate from the Didcot A station as part of the decommissioning process. [51]